Weider WEBE96491 manual

7.Attach the Backrest (15) to the Backrest Tubes (27) with four M6 x 52mm Screws (4) and four M6 Washers (30).

8.Attach the Seat (14) to the indicated brackets on the Bench Frame (5) with four M6 x 16mm Screws (3).

9.Press a 3/4Ó Round Inner Cap (12) into each end of the three Pad Tubes (38).

Slide a Foam Pad (10) onto one end of each Pad Tube (38).

Slide the Pad Tubes (38) into the indicated holes in the Leg Lever (18) and the bracket on the Front Leg (19). Slide another Foam Pad (10) onto the other end of each Pad Tube.

10.Press a Base Outer Cap (69) onto each end of the Left Base (2) and the Right Base (7). Place both bases on the floor and orient them as shown in the drawing.

Orient the Rear Base (8) as shown and insert the ends into the brackets on the Left Base (2) and the Right Base (7). Secure the Rear Base with four M10 x 78mm Bolts (33) and four M10 Nylon Locknuts (11).

Note: Do not tighten the Nylon Locknuts yet.

7	15
	27		30
			4
	30	30
		4
8
	14
			5
		3
		3
9	10	Bracket
		19
			38
18
	10	12
12			12
	38	38		10
	12
		10
10		11
		8
	33		Decal
				11
	7	69
			33
69				69
		69	2

8