Weider WEBE03820 user manual Adjustments, Adjusting the Backrest, Attaching Weights

Page 10

ADJUSTMENTS

The weight bench is designed to be used with your own weight set (not included). The steps below explain how the weight bench can be adjusted. See EXERCISE GUIDELINES on page 13 for important exercise information and refer to the accompanying exercise guide to see the correct form for several exercises.

Make sure all parts are properly tightened each time you use the weight bench. Replace any worn parts immediate- ly. The weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.

ADJUSTING THE BACKREST

The Backrest (6) can be used in a declined position, a level position, or two inclined positions. To use the Backrest in a declined position, remove the Support Rod (7) and lay the Backrest on the Crossbar (3).

To use the Backrest (6) in a level position or an inclined position, insert the Support Rod (7) through a set of holes in the Uprights (1). Rotate the Support Rod to the locked position, so the locking pin is wrapped around the Upright. Rest the Backrest on the Support Rod.

Note: Always insert the Support Rod (7) into the Uprights (1) so that the locking pin wraps around the back of the Upright.

ATTACHING WEIGHTS

To use the Leg Lever (4), slide the desired weights (not included) onto the weight tube on the Leg Lever.

To use the Fly Arms (25) or the Lat Tower (40), make sure there is a Weight Stop (28) on each weight tube or each side of the Weight Carriage (48). Next, slide the desired weights (not included) onto the weight tubes or the Weight Carriage. Secure the weights on the Weight Carriage with the two Weight Clips (50).

WARNING: When you are using the Leg Lever (4), place a barbell (not included) with the same amount of weight on the Weight Rests (51) to balance the bench.

Do not place more than 50 pounds on the Leg Lever (4) or the Weight Carriage (48). Do not place more than 30 pounds on each Fly Arm (25).

1

1

 

 

Locking

 

 

Pin

 

6

7

 

 

 

3

 

 

51

 

40

 

 

25

 

 

50

 

 

48

 

 

28

25

 

 

28

 

Weight

50

Weight

4

Weight

Tube

 

Weight

 

 

Tube

 

 

Weight

 

 

10

Image 10
Contents Model No. WEBE03820 Serial No QUESTIONS?Customer HOT Line Table of Contents Important Precautions Before YOU Begin DecalAssembly Make Things Easier for YourselfPage Overtighten the Locknut the Backrest Tubes Washers 26. Do not tighten the Screws yetAssemble the other Fly Arm not shown Same manner Repeat this step for the other Fly Arm not shown Page Adjusting the Backrest AdjustmentsAttaching Weights Removing and Attaching the FLY Arms Attaching the LAT TowerAdjusting the Weight Rests Attaching the LAT BARExercise Guidelines Cooling Down Muscle ChartStaying Motivated Aerobic Exercise Exercise Weight Sets RepsDate Thursday Aerobic Exercise DateLimited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Page Part Identification Chart Part LIST-Model No. WEBE03820 Qty DescriptionExploded DRAWING-Model No. WEBE03820