Weider WEBE03820 user manual Washers 26. Do not tighten the Screws yet

7.	Tap two 25mm Square Inner Caps (35) into each	7		30
	of the two Backrest Tubes (5).
	Attach each Backrest Tube (5) to the Backrest (6)			35
			26
	with two M6 x 38mm Screws (30) and two M6
	Washers (26). Do not tighten the Screws yet.
		30	5
		26		6
		35
8.	Tap a 19mm Round Inner Cap (9) into each end	8	1
	of the Support Rod (7). Insert the Support Rod
	into one of the three upper sets of holes in the
	Uprights (1). Rotate the Support Rod to the			1
	locked position, with the locking pin wrapped
	around the Upright. Note: Always insert the			9
	Support Rod into the Uprights so that the
	locking pin wraps around the back of the	36
	Upright.			7
		34
	Lubricate the M10 x 135mm Bolt (36) with grease.				9
		5
	Attach the Backrest Tubes (5) to the welded tube		34	2
	on the Frame (2) with the Bolt, two M10 Washers
	(34), and an M10 Nylon Locknut (33). Do not		33		Locking
	overtighten the Locknut; the Backrest Tubes	Welded Tube			Pin
	must be able to pivot easily.
	Tighten the M6 x 38mm Screws (30) used in	9
		11
	step 7, and the Nylon Locknuts (17, 33) used
	in steps 1 to 3.
9.	Attach the Seat (11) to the brackets on the Frame
	(2) with four M6 x 16mm Screws (29).		2
				29
			29
10.	Press two 30mm Square Inner Caps (22) into the	10		25
	ends of a Fly Arm (25). Press a 25mm Round
	Inner Cap (24) into the end of the weight tube.			22
	Slide a Weight Stop (28) onto the weight tube.
	Assemble the other Fly Arm (not shown) in
	the same manner.			24	28
		22	Weight
				Tube
		7