11.Tap a Fly Arm Stop (15) onto the welded tube on each Upright (1).
Press two Plastic Bushings (14) into the indicated holes in an Upright (1). Attach a Fly Arm (25) to the Upright using an M10 x 115mm Bolt (19) and a Butterfly Knob (13). Make sure the Fly Arm is on the outside of the Fly Arm Stop (15). Do not overtighten the Butterfly Knob; the Fly Arm must be able to pivot easily.
Attach the other Fly Arm (not shown) to the other Upright (1) in the same manner.
12.Push a 19mm Round Inner Cap (9) into the end of a Short Pad Tube (12). Slide the Short Pad Tube as far as it will go into the indicated hole in the a Fly Arm (25), as shown. Slide a Short Foam Pad (27) onto the Pad Tube.
Repeat this step for the other Fly Arm (not shown).
13.Route the eyelet end of the Cable (39) through the hole in the Lat Tower (40) and over the Pulley (44). Attach the Pulley, two Spacers (43), and two M10 Washers (34) to the Lat Tower with an M10 x 55mm Bolt (42) and an M10 Nylon Locknut (33).
Press a 38mm Square Inner Cap (21) into the top of the Lat Tower (40).
Insert two Square Bushings (47) into the top and bottom of the Weight Carriage (48). Press two 25mm Round Inner Caps (24) into the ends of the weight tube on the Weight Carriage. Slide two Weight Stops (28) onto the weight tube.
Slide an M8 x 16mm Screw (45) into the bracket on the Weight Carriage (48).
Slide the Weight Carriage (48) onto the Lat Tower (40). Attach the Cable (39) to the M8 x 16mm Screw (45) with an M8 Nylon Locknut (17).
11 |
|
|
14 | 14 | 13 |
|
| |
| 1 |
|
1 |
|
|
25 | 15 |
|
19 |
|
|
12 |
|
|
| 12 |
|
25 |
|
|
| 9 |
|
27 |
|
|
13 | 21 |
|
|
| |
42 | 39 |
|
34 |
|
|
43 | 33 |
|
44 | 34 |
|
43 |
| |
|
| |
| 40 |
|
39 |
|
|
17 |
|
|
| 45 |
|
28 | 47 |
|
24 |
|
|
| 48 |
|
Bracket | 24 |
|
47 | 28 |
|
|
|
8