CARING FOR YOUR DRYER
CLEANING THE LINT SCREEN
Every load cleaning
The lint screen is located under a lid on top of the dryer. Clean it before starting each load. A screen blocked by lint can increase drying time.
To clean:
1.Open the lid and pull the lint screen towards you.
2.Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is
hard to remove.
3.Push the lint screen firmly back into place and close the lid.
As needed cleaning
Laundry detergents and fabric softeners can cause a residue buildup on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is com- pletely dry. You may be able to see this buildup, or the lint may be falling off the screen because it is clogged.
Clean the lint screen with a nylon brush every six months or more frequently if it becomes clogged due to a residue buildup.
Use the following method:
1.Wet both sides of lint screen with hot water.
2.Wet a nylon brush with hot water and liquid detergent; scrub lint screen with the brush
to remove residue buildup.
3.Rinse screen with hot water.
4.Thoroughly dry lint screen with a clean towel; replace in dryer.
IMPORTANT:
•Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics.
•Some towels made of synthetic fibers and natu- ral fibers (polyester and cotton blends) may shed more lint than other towels, causing your dryer’s lint screen to fill up faster. Be sure to remove lint from the lint screen before and after drying new towels.
•If lint falls off the screen during removal and into the dryer, check the exhaust hood and remove the lint (see "Checking Your Vent").
15