Miele W 2240 operating instructions Use

Page 7

Warning and safety instructions

This machine must only be connected to the on-site water

supply using a new hose kit. Old hoses must not be re-used. Check the hose regularly for signs of wear and tear. Change in good time to avoid the risk of leaks and subsequent damage.

Faulty components must only be replaced by genuine Miele original

spare parts. Only when these parts are fitted can the safety standards of the machine be guaranteed.

If the connection cable is faulty it must only be replaced by a Miele approved service technician to protect

the user from danger.

In countries where there are areas which may be subject to infestation

by cockroaches or other vermin, pay particular attention to keeping the machine and its surroundings in a clean condition at all times. Any damage which may be caused by cockroaches or other vermin will not be covered by the machine guarantee.

Use

This equipment may only be used in mobile installations such as

ships, caravans, aircraft etc. if a risk assessment of the installation has been carried out by a suitably qualified engineer.

Do not install your washing machine in rooms where

temperatures below freezing may occur. Frozen hoses may burst under pressure. The reliability of the electronic control unit may be impaired at temperatures below freezing point.

Before using the machine for the first time, check that the transit

fitting at the rear of the machine has been removed (see section on "Installation"). During spinning, a transit fitting which is still in place may result in damage to both the machine and adjacent furniture or appliances.

Turn off the stopcock if the machine is to be left for any length

of time (e.g. holiday), especially if there is no floor drain (gully) in the immediate vicinity.

Flooding danger

If hooking the drain hose into a wash basin, check that the water can drain off quickly enough to prevent the sink from overflowing.

Make sure the drain hose is secure, so that the force of the water flowing out of the hose does not dislodge it.

Otherwise this will result in flooding.

Take care to ensure that foreign objects (e.g. nails, pins, coins,

paper clips) do not find their way into the machine with the laundry. These may damage components of the machine (e.g. suds container, drum), which in turn can result in damage to the laundry.

7

Image 7 Contents
Operating instructions for Washing machine W Disposal of the packing material Caring for our environmentDisposal of your old appliance or machine Contents Contents Technical data Correct usage Technical safetyUse Accessories Safety with childrenDisposal of your old machine Water plus system Description of the machineSpecial programmes Delicates and Silks / programmesFuture updates PC Control panel Programme duration Additional option buttons Important control panel featuresSpin button with indicator lights Select the spin speed Programme selectorBefore using for the first time Detergent When drying with a tumble dryerWashing environmentally and economically Energy and water consumptionBrief instructions How to wash correctlyMinimum iron 30C to 60C Programme chart Cottons 30C to 95C 9ö876Silks 30C /c Delicates cold to 40CWoollens cold to 40C /ac Separate rinse Quick wash 40CAutomatic 40C StarchTumble dry Garment care label symbolsIroning ASort the laundry Before washingSelecting a programme Soak Additional options HSelect additional optionsIntensive Pre-washJPress the Start button IAdding detergentLRemove the laundry MSwitch off the washing machineAt the end of a programme KOpen the drum doorPlease note Adding or removing laundry after a programme has startedDoor cannot be opened, if Skipping a programme stage To cancel or select a different programmeInterrupting a programme Altering a programme once selectedMain wash Rinses Spinning Programme sequenceSpecial features in the programme sequences Liquid detergent DetergentWater softeners Washing with several componentsAdding starch separately Fabric conditioners and liquid starchColour run and dye removers/ dyes Adding fabric conditioner separatelyExtra cleaning Cleaning and careCloth Clean the siphon Cleaning the detergent dispenser drawerTo clean the filter in the water inlet valve Cleaning the water inlet filtersProblem Possible cause Remedy Problem solving guideProgramme does not start System has reacted Flashing Appears in the display Wash programme stops and a fault indicator light comes onProblem Possible cause Remedy a Water protection Call the Service DepartmentFlashes Indicator light isCheck light comes on General problems or an unsatisfactory wash result Grey, greasy Problem Possible cause Remedy Liquid detergentDoes not give Required resultDrum door does not open when you press the Door button Blocked drain outlet Use it to open the access flapProcedure for draining the machine Remove the leverOpening the drum door Customer contact Optional accessoriesFront view Installation and connectionRear view Installing the washing machine Installation surfaceRemoving the transit fittings Withdraw the transit bar Re-fitting the transit bars Levelling the machine Screwing out and adjusting the feetWasher and Dryer stack Building under a continuous worktop/in a kitchen runReplacing the lid Drain hose Electronic unit and washing machine housingMiele water protection system Inlet hoseConnection to the water supply Maintenance and careExtension hose Drain hose connection Connection to the drainage systemElectrical connection U.K Non-rewireable plugs BSConsumption data Technical data Programmable functions For changing standard settings Programmable functions Settings are as followsWater plus system Programmable functions Follow steps a to G to programme and store in memory Gentle actionTop-up rinse for Cottons Memory Function Soak Alteration rights reserved/5104/W