Miele Premier 300 operating instructions Wash programme stops and a fault indicator light comes on

Page 37

Problem solving guide

The wash programme stops and a fault indicator light comes on.

Fault indicator	Possible cause	Remedy A
The Check drain light	The water outlet is	Clean the fluff (drain)
flashes.	blocked.	filter and drain pump.
	The drain hose has been	The maximum drain
	fixed too high.	height is 1 m.
The Check inlet light	The water inlet is blocked.	Open the stopcock.
flashes.	The filter in the water inlet	Clean the filter.
	The filter in the water inlet	Clean the filter.
	hose is dirty.
The Check inlet and	The water protection	Call the Service
Check drain lights flash.	system has reacted.	Department.
The Soak/Pre-wash or	There is a fault.	Start the programme
Rinses indicator light		again.
flashes in the		If the fault indicators
programme sequence.		occur again, contact the
		Service Department.

ATo switch off the fault indicator: Switch off the machine with the I-On/0-Offbutton and turn the programme selector to Finish

37

Image 37

Contents Operating instructions for Washing machine Premier Disposal of the packing material Caring for our environmentDisposal of your old appliance Contents Contents Consumption data Technical data Correct usage Technical safetyUse Disposal of your old machine AccessoriesSpecial programmes Description of the applianceDelicates and Silks / programmes Water plus systemFuture updates PC Control panel Important control panel features Before using for the first time Washing environmentally and economically Brief instructions How to wash correctlyMinimum iron 4321 Programme chart Cottons 9ö876Silks /c DelicatesWoollens /ac + cold Mixed wash Quick washStarch Separate rinseTumble dry Important other care symbolsIroning ASort the laundry Before washingSelecting a programme Short Additional options HSelect additional options if requiredPre-wash SoakLiquid detergent IAdd detergentJPress the Start button At the end of a programme MSwitch off the washing machineKOpen the drum door LRemove the laundryDoor cannot be opened, if Adding or removing laundry after a programme has startedInterrupting a programme To cancel or select a different programmeAltering a programme once selected Skipping a programme stageCottons Programme sequenceMinimum iron SilksWoollens Special features in the programme sequencesWater softeners DetergentWashing with several components Right amount to dispense will depend on the followingColour run and dye removers/dyes Fabric conditioners and liquid starchAdding fabric conditioner separately Adding starch separatelyExtra cleaning Cleaning and careCloth Clean the siphon Cleaning the detergent dispenser drawerUse it to open the access flap Cleaning the fluff drain filter and pumpProcedure for draining the machine Remove the openerAfter cleaning Clean the fluff filter thoroughlyTo clean the filter in the water inlet valve Cleaning the water inlet filtersChart is divided into the following sections to help you Problem solving guideFault indicator Possible cause Remedy Using for the first time Been selectedFault indicator Possible cause Remedy a Wash programme stops and a fault indicator light comes onIndicator light flashes Main wash indicatorCheck light comes on Light flashesGeneral problems or an unsatisfactory wash result Does not give Problem Possible cause Remedy Liquid detergentRequired result Grey, greasyDrum door does not open when you press the Door button Remove the lever Opening the drum door in the event of a power failureCustomer contact Front view Installation and connectionRear view Installing the washing machine Installation surfaceRemoving the transit fittings Withdraw the transit bar Re-fitting the transit bars Levelling the machine Screwing out and adjusting the feetWasher and Dryer stack Building under a continuous worktop/in a kitchen runPlease note Replacing the lidMiele water protection system Electronic unit and washing machine housingInlet hose Drain hoseConnection to the water supply Maintenance and careExtension hose Drain hose connection Connection to the drainage systemElectrical connection U.K Non-rewireable plugs BS Programme Load Consumption data Consumption dataEnergy DurationTechnical data Page Programmable functions for changing standard settings Programmable functions Settings are as followsWater plus system Programmable functions Follow steps a to G to programme and store in memory Gentle actionHas been activated Does not flash Top-up rinse for CottonsBeen activated ActivatedMemory function Soak Page Page Alteration rights reserved/4103