Miele Premier 300 operating instructions Programme Load Consumption data, Energy, Duration

Page 56

Consumption data

Programme	Load		Consumption data
(without any additional		Energy	Water	Duration
options or		Energy	Water	Duration
		in kWh	in litres	normal		Short

programmable
functions)
Cottons
95°C	5.0 kg	1.70	45	1 h 47 min		1 h 32 min

60°C1)	5.0 kg	0.95	45	1 h 56 min		1 h 26 min
40°C	5.0 kg	0.50	45	1 h 56 min		1 h 26 min

Minimum iron
40°C	2.5 kg	0.45	49	1 h 16 min		1 h 01 min

Delicates
30°C	1.0 kg	0.35	65	59 min		49 min

Silks /
30°C	1.0 kg	0.24	39	37 min		–
Woollens /
30°C	2.0 kg	0.23	35	40 min		–

1) EN 60456 test programme

Consumption data can vary from the nominal values given depending on water pressure, water hardness, water inlet temperature, room temperature, type and volume of load, fluctuations in the electricity supply and any additional options selected.

N.B.

Consumption data obtained from a machine tested in Germany.

56

Image 56

Contents Operating instructions for Washing machine Premier Disposal of your old appliance Caring for our environmentDisposal of the packing material Contents Contents Consumption data Technical data Technical safety Correct usageUse Accessories Disposal of your old machineDescription of the appliance Special programmesDelicates and Silks / programmes Water plus systemFuture updates PC Control panel Important control panel features Before using for the first time Washing environmentally and economically How to wash correctly Brief instructionsProgramme chart Cottons 9ö876 Minimum iron 4321Woollens /ac + cold DelicatesSilks /c Quick wash Mixed washStarch Separate rinseIroning Important other care symbolsTumble dry Before washing ASort the laundrySelecting a programme Additional options HSelect additional options if required ShortPre-wash SoakJPress the Start button IAdd detergentLiquid detergent MSwitch off the washing machine At the end of a programmeKOpen the drum door LRemove the laundryAdding or removing laundry after a programme has started Door cannot be opened, ifTo cancel or select a different programme Interrupting a programmeAltering a programme once selected Skipping a programme stageProgramme sequence CottonsMinimum iron SilksSpecial features in the programme sequences WoollensDetergent Water softenersWashing with several components Right amount to dispense will depend on the followingFabric conditioners and liquid starch Colour run and dye removers/dyesAdding fabric conditioner separately Adding starch separatelyCloth Cleaning and careExtra cleaning Cleaning the detergent dispenser drawer Clean the siphonCleaning the fluff drain filter and pump Use it to open the access flapProcedure for draining the machine Remove the openerClean the fluff filter thoroughly After cleaningCleaning the water inlet filters To clean the filter in the water inlet valveProblem solving guide Chart is divided into the following sections to help youFault indicator Possible cause Remedy Using for the first time Been selectedWash programme stops and a fault indicator light comes on Fault indicator Possible cause Remedy aMain wash indicator Indicator light flashesCheck light comes on Light flashesGeneral problems or an unsatisfactory wash result Problem Possible cause Remedy Liquid detergent Does not giveRequired result Grey, greasyDrum door does not open when you press the Door button Opening the drum door in the event of a power failure Remove the leverCustomer contact Installation and connection Front viewRear view Removing the transit fittings Installation surfaceInstalling the washing machine Withdraw the transit bar Re-fitting the transit bars Screwing out and adjusting the feet Levelling the machineBuilding under a continuous worktop/in a kitchen run Washer and Dryer stackPlease note Replacing the lidElectronic unit and washing machine housing Miele water protection systemInlet hose Drain hoseExtension hose Maintenance and careConnection to the water supply Connection to the drainage system Drain hose connectionElectrical connection U.K Non-rewireable plugs BS Consumption data Programme Load Consumption dataEnergy DurationTechnical data Page Programmable functions for changing standard settings Water plus system Settings are as followsProgrammable functions Programmable functions Has been activated Gentle actionFollow steps a to G to programme and store in memory Top-up rinse for Cottons Does not flashBeen activated ActivatedMemory function Soak Page Page Alteration rights reserved/4103