Miele Premier 300 operating instructions Use

Page 7

Warning and safety instructions

This machine must only be connected to the on-site water

supply using a new hose kit. Old hoses must not be re-used. Check the hose regularly for signs of wear and tear. Change in good time to avoid the risk of leaks and subsequent damage.

Faulty components must only be replaced by genuine Miele original

spare parts. Only when these parts are fitted can the safety standards of the machine be guaranteed.

If the connection cable is faulty it must only be replaced by a Miele approved service technician to protect

the user from danger.

In countries where there are areas which may be subject to infestation

by cockroaches or other vermin, pay particular attention to keeping the appliance and its surroundings in a clean condition at all times. Any damage which may be caused by cockroaches or other vermin will not be covered by the appliance guarantee.

Use

This equipment is not designed for maritime use or for use in mobile

installations such as caravans, aircraft etc. However it may be suitable for such usage subject to a risk assessment of the installation being carried out by a suitably qualified engineer.

Do not install your washing machine in rooms where

temperatures below freezing may occur. Frozen hoses may burst under pressure. The reliability of the electronic control unit may be impaired at temperatures below freezing point.

Before using the machine for the first time, check that the transit

fitting at the rear of the machine has been removed (see section on "Installation"). During spinning, a transit fitting which is still in place may result in damage to both the machine and adjacent furniture or appliances.

Turn off the stopcock if the machine is to be left for any length

of time (e.g. holiday), especially if there is no floor drain (gully) in the immediate vicinity.

Flooding danger.

If hooking the drain hose into a wash basin, check that the water can drain off quickly enough to prevent the sink from overflowing.

Make sure the drain hose is secure, so that the force of the water flowing out of the hose does not dislodge it.

Otherwise this will result in flooding.

Take care to ensure that foreign objects (e.g. nails, pins, coins,

paper clips) do not find their way into the machine with the laundry. These may damage components of the machine (e.g. suds container, drum), which in turn can result in damage to the laundry.

7

Image 7
Contents Operating instructions for Washing machine Premier Disposal of the packing material Caring for our environmentDisposal of your old appliance Contents Contents Consumption data Technical data Correct usage Technical safetyUse Disposal of your old machine AccessoriesWater plus system Description of the applianceSpecial programmes Delicates and Silks / programmesFuture updates PC Control panel Important control panel features Before using for the first time Washing environmentally and economically Brief instructions How to wash correctlyMinimum iron 4321 Programme chart Cottons 9ö876Silks /c DelicatesWoollens /ac + cold Separate rinse Quick washMixed wash StarchTumble dry Important other care symbolsIroning ASort the laundry Before washingSelecting a programme Soak Additional options HSelect additional options if requiredShort Pre-washLiquid detergent IAdd detergentJPress the Start button LRemove the laundry MSwitch off the washing machineAt the end of a programme KOpen the drum doorDoor cannot be opened, if Adding or removing laundry after a programme has startedSkipping a programme stage To cancel or select a different programmeInterrupting a programme Altering a programme once selectedSilks Programme sequenceCottons Minimum ironWoollens Special features in the programme sequencesRight amount to dispense will depend on the following DetergentWater softeners Washing with several componentsAdding starch separately Fabric conditioners and liquid starchColour run and dye removers/dyes Adding fabric conditioner separatelyExtra cleaning Cleaning and careCloth Clean the siphon Cleaning the detergent dispenser drawerRemove the opener Cleaning the fluff drain filter and pumpUse it to open the access flap Procedure for draining the machineAfter cleaning Clean the fluff filter thoroughlyTo clean the filter in the water inlet valve Cleaning the water inlet filtersUsing for the first time Been selected Problem solving guideChart is divided into the following sections to help you Fault indicator Possible cause RemedyFault indicator Possible cause Remedy a Wash programme stops and a fault indicator light comes onLight flashes Main wash indicatorIndicator light flashes Check light comes onGeneral problems or an unsatisfactory wash result Grey, greasy Problem Possible cause Remedy Liquid detergentDoes not give Required resultDrum door does not open when you press the Door button Remove the lever Opening the drum door in the event of a power failureCustomer contact Front view Installation and connectionRear view Installing the washing machine Installation surfaceRemoving the transit fittings Withdraw the transit bar Re-fitting the transit bars Levelling the machine Screwing out and adjusting the feetReplacing the lid Building under a continuous worktop/in a kitchen runWasher and Dryer stack Please noteDrain hose Electronic unit and washing machine housingMiele water protection system Inlet hoseConnection to the water supply Maintenance and careExtension hose Drain hose connection Connection to the drainage systemElectrical connection U.K Non-rewireable plugs BS Duration Consumption dataProgramme Load Consumption data EnergyTechnical data Page Programmable functions for changing standard settings Programmable functions Settings are as followsWater plus system Programmable functions Follow steps a to G to programme and store in memory Gentle actionHas been activated Activated Top-up rinse for CottonsDoes not flash Been activatedMemory function Soak Page Page Alteration rights reserved/4103