Miele Premier 300 Check light comes on, Main wash indicator, Light flashes, Display, Programme

Page 38

Problem solving guide

A fault indicator light comes on but the wash programme con- tinues as normal.

Fault indicator	Possible cause	Remedy A
The Check drain light	The drain outlet is	Clean the fluff (drain) filter
flashes.	restricted.	and drain pump.
The Check inlet light	The water inlet is	Check whether
flashes.	restricted.	– the stopcock is opened
		wide enough.
		– the inlet hose is kinked.
	The filter in the inlet	Clean the filter.
	hose is dirty.
The Excess detergent	Excessive foam has	Use less detergent next
check light comes on.	built up during	time and follow the
	washing.	recommendation on the
		packaging.
The Main wash indicator	There is a fault.	Start the programme again.
light flashes in the		If the fault indicator occurs
programme sequence		again, contact the Service
display.		Dept.
The Anti-crease/Finish	The position of the programme selector was altered
indicator light flashes in	after the start of the programme. Turn the
the programme	programme selector back to the programme
sequence display.	previously chosen.

ATo switch off the fault indicator: Switch off the machine with the I-On/0-Offbutton and turn the programme selector to Finish

38

Image 38

Contents Operating instructions for Washing machine Premier Disposal of your old appliance Caring for our environmentDisposal of the packing material Contents Contents Consumption data Technical data Technical safety Correct usageUse Accessories Disposal of your old machineDelicates and Silks / programmes Description of the applianceSpecial programmes Water plus systemFuture updates PC Control panel Important control panel features Before using for the first time Washing environmentally and economically How to wash correctly Brief instructionsProgramme chart Cottons 9ö876 Minimum iron 4321Woollens /ac + cold DelicatesSilks /c Starch Quick washMixed wash Separate rinseIroning Important other care symbolsTumble dry Before washing ASort the laundrySelecting a programme Pre-wash Additional options HSelect additional options if requiredShort SoakJPress the Start button IAdd detergentLiquid detergent KOpen the drum door MSwitch off the washing machineAt the end of a programme LRemove the laundryAdding or removing laundry after a programme has started Door cannot be opened, ifAltering a programme once selected To cancel or select a different programmeInterrupting a programme Skipping a programme stageMinimum iron Programme sequenceCottons SilksSpecial features in the programme sequences WoollensWashing with several components DetergentWater softeners Right amount to dispense will depend on the followingAdding fabric conditioner separately Fabric conditioners and liquid starchColour run and dye removers/dyes Adding starch separatelyCloth Cleaning and careExtra cleaning Cleaning the detergent dispenser drawer Clean the siphonProcedure for draining the machine Cleaning the fluff drain filter and pumpUse it to open the access flap Remove the openerClean the fluff filter thoroughly After cleaningCleaning the water inlet filters To clean the filter in the water inlet valveFault indicator Possible cause Remedy Problem solving guideChart is divided into the following sections to help you Using for the first time Been selectedWash programme stops and a fault indicator light comes on Fault indicator Possible cause Remedy aCheck light comes on Main wash indicatorIndicator light flashes Light flashesGeneral problems or an unsatisfactory wash result Required result Problem Possible cause Remedy Liquid detergentDoes not give Grey, greasyDrum door does not open when you press the Door button Opening the drum door in the event of a power failure Remove the leverCustomer contact Installation and connection Front viewRear view Removing the transit fittings Installation surfaceInstalling the washing machine Withdraw the transit bar Re-fitting the transit bars Screwing out and adjusting the feet Levelling the machinePlease note Building under a continuous worktop/in a kitchen runWasher and Dryer stack Replacing the lidInlet hose Electronic unit and washing machine housingMiele water protection system Drain hoseExtension hose Maintenance and careConnection to the water supply Connection to the drainage system Drain hose connectionElectrical connection U.K Non-rewireable plugs BS Energy Consumption dataProgramme Load Consumption data DurationTechnical data Page Programmable functions for changing standard settings Water plus system Settings are as followsProgrammable functions Programmable functions Has been activated Gentle actionFollow steps a to G to programme and store in memory Been activated Top-up rinse for CottonsDoes not flash ActivatedMemory function Soak Page Page Alteration rights reserved/4103