Miele W 3364 WPS operating instructions Add detergent

Page 16

How to wash correctly

H Add detergent

It is important to dispense the correct amount, because . . .

. . . too little detergent results in:

–Laundry not getting properly clean and and in time becoming grey and hard to the touch.

–Greasy particles clinging to the laundry.

–Limescale deposits on the heater elements.

. . . too much results in:

–Excessive foam which causes a low level of agitation and poor wash, rinse and spin results.

–Higher water consumption (an additional rinse cycle will automatically switch in).

–A burden to the environment.

^Pull out the detergent drawer and place detergent in the compartments as follows:

i

Detergent for Pre-wash (if selecting Pre-wash, add 1/4 of the total amount recommended). This compartment is also used for starch formulations when starching separately.

j

Detergent for the main wash, including Soak if selected

§

Fabric conditioners or liquid starch

^Close the detergent drawer.

See "Detergent" for further information.

16

Image 16

Contents Operating instructions for Washing machine W 3364 WPS Disposal of the packing material Caring for our environmentDisposal of your old appliance or machine Contents Contents Consumption data Technical data Technical safety Correct usageUse Accessories Safety with childrenDisposal of your old machine Description of the machine Control panelProgramme duration Delay startProgrammable functions Before using for the first time When drying with a tumble dryer Washing environmentally and economicallyEnergy and water consumption DetergentBrief instructions How to wash correctlySort the laundry Select Delay start if required Switch on the washing machine Load the drumSelect programme Shut the door with a gentle swing Select additional options Select a spin speed Add detergent Start the programme Unload the drumAdditional options ShortPre-wash SoakSpinning Final spin speedRinse and interim spin To omit the final spin Rinse holdDelay start Select Delay startTo alter Delay start To cancel Delay startCottons 30C to 95C Minimum iron* 30C to 60CDelicates cold to 40C 21ac Automatic 40CProgramme chart Garment care label symbols Programme sequence Main wash Rinses SpinningSpecial features in the programme sequences Cancelling a programme Changing the programme sequenceChanging a programme Interrupting a programmeAdding or removing laundry after a programme has started Correct detergent DetergentAll purpose Detergent for Coloured fabrics Delicates Whites Washing with several components Water softenersRight amount to dispense will depend on the following Colour run and dye removers / dyes Fabric conditioners and liquid starchAdding fabric conditioner or starch separately Cleaning and care Cleaning the detergent dispenser drawerExtra cleaning External casing and fascia panelCleaning the detergent dispenser drawer housing Cleaning the filter in the water inlet Problem Possible cause Remedy Problem solving guideProgramme does not start Wash programme stops and a fault indicator light comes on Fault indicator Possible cause Remedy aWater protection Call the Service Department System has reacted Flashing. - appears DisplayFlashes Indicator light isCheck light comes on General problems An unsatisfactory wash result Drum door does not open when you press the Door button Procedure for draining the machine Use it to open the access flapBlocked drain outlet Remove the leverOpening the drum door After sales service Future updates PCAppliance guarantee Optional accessoriesInstallation and connection Front viewRear view Installing the washing machine Installation surfaceRemoving the transit bars Withdraw the transit bar Re-fitting the transit bars Screwing out and adjusting the feet Levelling the machinePlease note Replacing the lidElectronic unit and washing machine housing Miele Waterproof systemInlet hose Drain hoseConnection to the water supply Maintenance and care Extension hoseConnection to the drainage system Drain hose connectionNon-rewireable plugs BS Electrical connection U.KConsumption data Technical data Programmable functions For changing default settings Water plus system Programmable functionsFollow steps a to G to programme and store in memory Gentle action Suds cooling for Cottons Memory function Soak duration Page Alteration rights reserved/4506/W 3364 WPS