Installation and connection
The fitting of building under kits and stacking kits must only be undertaken by qualified and competent persons, in accordance with the instructions supplied with the kit.
Building under a continuous worktop/in a kitchen run
Washer and Dryer stack
A Miele tumble dryer can be stacked with the washing machine. A "WTV" stacking kit* is necessary and can be purchased from the Miele Spare Parts Department.
Please note
If you wish to push your machine under a worktop and there is space to do this without removing the lid, the conversion kit is not necessary. Otherwise the conversion kit is essential.
–A special building under conversion kit* is required.
The machine lid must be replaced by a cover plate. To ensure electrical safety the cover plate must be fitted.
–For installation under a work surface 900/910 mm from the floor, a raising kit* is required.
–Connections for electricity, water and drainage should be installed in such a way that they remain accessible when the machine is in place.
Fitting instructions are supplied with the conversion kit.
All parts marked* are available from your Dealer or the Miele Spare Parts Department.
aSafety distance to wall: at least 2 cm
bHeight:
Stacking kit with
Stacking kit without
Replacing the lid
If the lid has been removed in order to fit a stacking kit or cover plate, ensure that, if the lid is replaced, it fits securely into the rear holders. Otherwise, it is not properly secure for transport.
49