Instructions for use
Start the Washing Program
0 1. Check that the water valve is open.
2. Start the washing program: Press the button
START/PAUSE (START/PAUZE, MARCHE/PAUSE). The washing program is started or it starts after the set time expires.
3 | The filling door is not correctly closed if, when the button START/PAUSE |
| (START/PAUSE, MARCHE/PAUSE) is pressed, |
– the indicator DOOR (DEUR, PORTE) flashes red
– the fault code E40 in the multidisplay flashes
– and the indicator MAIN WASH (HOOFDWAS, LAVAGE) flashes.
In this case, press the filling door firmly closed and again press the but- ton START/PAUSE (START/PAUZE, MARCHE/PAUSE).
If the time preselection is set:
A set time preselection runs and the remaining time until the program start is displayed (in each case in full hours, e. g. 5h). During this time you can load washing or change/abort the time preselection.
• Load washing: Press the button START/PAUSE (START/PAUZE, MARCHE/ PAUSE). The filling door can be opened. Next, close the door and again press the button START/PAUSE (START/PAUZE, MARCHE/PAUSE).
• Change or abort time preselection: Press the button DELAY TIMER (STARTTIJDKEUZE, DEPART DIFFERE) as often as necessary until the required time is displayed; when the program run time is displayed (display in minutes, e. g.129), the washing program starts without delay.
24