Setting up and connection instructions
2.Firmly pull both hose holders off the unit.
3 | The special button E and the plug |
| caps D (2 ea.) and G (1 ea.) are |
supplied with the unit.
3. Unscrew the two screws A using the special button E.
4. Unscrew the four screws B using the special button E.
5. Remove the transport rail C.
6. Screw the four screws B back in.
7. Close off the two large holes with the plug caps D.
Attention! Push in the plug caps so firmly that they engage in the rear panel (this protects the inside of the unit against splash water).
8. Remove the screw F, including the
sleeve, compression spring and washer, with the special button E.
9. Close off the hole with the plug cap G.
Attention! Push in the plug cap so firmly that it engages in the rear panel (this protects the inside of the unit against splash water).
45