AEG 76730 manual Setting Up the Unit, Transporting the Unit, Remove the Transport Safeguard, Tures

Page 44

Setting up and connection instructions

Setting Up the Unit

3	Washing machines with curved panels are not suitable for substruc-
	tures.

Transporting the Unit

•Do not place the washing machine on its front side or on its right side (looking from the front). Otherwise the electrical components can get wet.

•Never transport the unit without using the transport safeguard. Do not remove the transport safeguard until you reach the installation site. Transporting the unit without the transport safeguard can result in damage to the unit.

•Never lift the unit by the open filling door or by its base.

When transporting the unit with a sack trolley:

•Attach the sack trolley only at the side. The scoop of the sack trolley must not be longer than 24cm, otherwise the float switch can be destroyed.

Remove the Transport Safeguard

Attention! It is essential to remove the transport safeguard before putting the unit into oper- ation! Keep all parts of the trans- port safeguard in a safe place for possible later transport (moving house).

0 1. Open both hose holders on the rear of the unit and remove the hoses and the mains cable.

44

Image 44

Contents ÖKO-LAVAMAT 76730 update Dear customer Contents Remedying Faults What to do ifContents Correct Use SafetyBefore Putting into Operation for the First Time Child Safety General SafetyDisposal Environment TipsDispose the packing material Dispose the old applianceDrawer for Washing Powder and Care Agent Unit DescriptionFront View Control Panel Program SelectorMain washing cycle Cottons/Linen at 30 C to 95 C Time cannot be combined with Quick WASH/KORT/COURTWoollens WOL, LAINE/P Handwash Effect Additional Program ButtonsShorter washing cycle for slightly dirty washing Consumption Values and Time Requirements What Does Update Mean? Water Protection Aqua ControlSort and Prepare the Washing Before the First WashPrepare the Washing Cycle Washing Types and Care Codes How much washing detergent and care agent? Water SoftenerAfter the Washing Program Ends Run a Washing CycleBrief Instructions Set the Washing Program Press the button again to deselectSet the Delay Timer/Soaking Duration Change Spin Speed / Select Rinse HoldPer minute HoursSoaking Duration Pre-wash time of approx minutes= displayed value WAS, PRELAV. lights up on the program sequence displayOpening and Closing the Filling Door Add the WashingIf using Liquid Detergent/Tabs Add Washing Detergent/Care AgentCompartment for pre-wash agent/soaking agent Or for water softenerIf the time preselection is set Start the Washing ProgramSTART/PAUSE, MARCHE/PAUSE is pressed Multi-Display Completion of the Washing ProgramProgram Sequence Display Changing a Washing Program Changing or aborting a programSelect the Additional Program Change the Spin SpeedWashing Cycle Ended/Remove Washing Program Tables WashingEASY-CARES PRE Wash Separate Spin Separate Conditioning/Starching/ImpregnatingSeparate Rinse Cleaning and Care Washing Detergent DrawerWashing Drum Filling DoorRemedying Faults What to do ifRINCAGE+ flashes Water Sans Repassage Washing detergent If the washing result is not satisfactory If the washing is grey and limescale forms in the drumIf there are still grey stains on the washing If foam is still visible after the final rinseCarry Out an Emergency Emptying Operation Clean the Solution Pump When all the washing solution has drained offMachine and pull out the mains plug Out Emergency EmptyingEmergency Unlocking of the Filling Door Set Additional Rinse Cancel Additional RinseAdditional Rinse RINSE+/SPOELEN+/RINCAGE+ Cancelling the Child Safety Feature Child Safety FeatureSetting the Child Safety Feature Setting UP and Connection Instructions Safety Instructions for InstallationSetting Up the Unit Remove the Transport SafeguardWhen transporting the unit with a sack trolley Transporting the UnitFirmly pull both hose holders off the unit Close off the hole with the plug cap GSetting Up on a Vibrating floor Prepare the Installation LocationSetting Up on a Concrete Pedestal Compensate for Floor Unevenness Permissible Water Pressure Electrical ConnectionWater Connection Water Inflow Draining the water into a basin Water DrainageWater Drainage into a Siphon Technical Data DimensionsDelivery Heads over 1m Measurements in mmPage Page Index Service When do you incur costs even during the warranty period?

Related manuals

Manual 56 pages 1.75 Kb