AEG 76760 manual Drainage hose bent Remove the bend Maximum pumping height

		Operating Instructions
Problem	Possible Cause	Remedy
	Drainage hose bent.	Remove the bend.
	Maximum pumping height	Contact your customer serv-
		ice. For pumping heights
	(discharge height 1m from
Washing is not well		over lm he can offer you a
	the unit's standing surface) is
spun. Residual water is		conversion kit as a special
still visible in the drum.	exceeded.	accessory.
Error code (2 is shown		Switch off the unit and pull
in the multi-display.
	Drain pump is blocked.	out the mains plug. Clean
		the drain pump.
	If a siphon is connected: Si-	Clean the siphon.
	phon blocked.
		Wait until the DOOR indica-
		tor lights up green.
		Should it nevertheless be
	The filling door is locked be-	necessary to open the main
		door:
	cause of a high water level or
		Turn the programme knob to
	a high temperature. The	OFF; turn the programme
	DOOR indicator lights red.
		knob to PUMP OUT. Press
		button START/PAUSE. The
The main door cannot		main door can be opened af-
be opened while the		ter the water has been
appliance is turned on.		pumped out.
		If water can be seen through
	Power failure!	the window in the door, first
		carry out emergency empty-
	(All indicators have gone
		ing (see section “Carrying out
	off.)
		Emergency Emptying Opera-
	For safety reasons the door
		tion").
	remains locked for 4 to
		After approx. 4 to 10 minutes
	10 minutes.
		the door can be opened
		again by pulling the handle.
	Water tap not fully opened.	Open the water tap fully.
Remnants of detergent	Filter in the screw connec-	Close the water tap. Unscrew
are building up in the	tion of the intake hose on	the inlet hose from the water
detergent drawer.
	the water tap or on the unit	tap and from the unit and
	is blocked.	clean the filter.

35