Installation and connection instructions
Electrical connection
Details of the mains voltage, current
type and required fuses can be found on the rating plate. The ra- ting plate is located at the top above the filling door.
For permanent electrical connection within the electrical circuit, provi-
sions must be made which allow for electrical disconnection of the ap- pliance from the mains with a contact opening of at least 3 mm at all poles. Suitable devices include circuit breakers, fuses (threaded fuses must be entirely removed from the socket), ground fault circuit inter- rupters and contactors. Permanent connection may only be carried out by an authorised electrician.
;This appliance complies with the following EC directives:
–The "Low Voltage Directive" 72/23/EU with changes
–The "EMC Directive" 89/336/EU with changes
Water connection
3 | The washing machine has safety features which prevent |
| nation of the drinking water and which conform to the national regu- |
lations of the water authorities (e.g. for Germany: DVGW guidelines). This means that additional protective measures in the installation are not necessary.
Important!
– Units for connecting to cold water must not be connected to hot wa- ter.
– Use only new hose sets for the connection.
Permissible water pressure
The water pressure must be at least 1 bar (= 10 N/cm2 = 0.1 Mpa), max- imum 10 bar = 100 N/cm2 = 1 Mpa).
•If more than 10 bar: Connect a
•If less than 1 bar: Unscrew the inlet hose on the unit side at the sole- noid intake valve and remove the flow regulator (to do this, remove the filter with pointed pliers and take out the rubber washer behind). Replace the filter.
45