Installation
NOTE: DO NOT slide washer across floor if the leveling legs have been extended, as legs and base could become damaged.
Remove rubber feet from accessories bag and place on all four leveling legs.
Verify that unit doesn’t rock.
| 2 | 3 |
|
| |
1 |
|
|
6 | 5 |
|
| FLW2114N | |
| 4 | |
|
| |
|
| FLW2114N |
1 | Leveling Leg |
|
2 | Washer Base |
|
3 | Level |
|
4 | Wood Block |
|
5 | Locknut |
|
6 | Rubber Foot |
|
Figure 3
Step 3: Connect Fill Hoses
WARNING
Under certain conditions, hydrogen gas may be produced in a hot water system that has not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot water system has not been used for such a period and before using the washer, turn on all hot water faucets and let the water flow from each for several minutes. This will release any accumulated hydrogen gas. The gas is flammable. Do not smoke or use an open flame during this time.
W029
Water Supply
Water supply faucets must fit standard 3/4 inch
(19.1 mm) female garden hose couplings. DO NOT USE
Water supply faucets should be readily accessible to permit turning them off when washer is not being used.
Recommended cold water temperature is 60° to 80° Fahrenheit (16° to 27 Celsius). Recommended maximum hot water temperature is 125° Fahrenheit (51° Celsius). Warm water is a mixture of hot and cold water. Warm water temperature is dependent upon water temperature and pressure of both the hot and cold water supply lines.
WARNING
To prevent personal injury, avoid contact with inlet water temperatures higher than 125° Fahrenheit (51° Celsius) and hot surfaces.
W748
Water pressure must be a minimum of 20 to a maximum of 120 pounds per square inch (138 to 827 kPa) static pressure measured at the faucet.
NOTE: Water pressure under 20 pounds per square inch (138 kPa) will cause an extended fill time in the washer and may not properly flush out the detergent dispenser.
8 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 802951 |