Installation
Step 6: Remove the Shock Sleeves and Shipping Brace
Remove front access panel by removing the two screws at the bottom of the panel.
Remove the five bolts and lockwashers from shipping brace with 9/16 in. wrench and remove brace. Refer to Figure 10. One is holding the brace to the weight.
Remove this bolt first. Four bolts are located on the washer base. Remove the two front bolts next and then the two rear bolts. Remove all four shock sleeves by pulling on the yellow rope. Remove label from front side of front access panel or shipping brace and place on backside of front access panel for future reference.
NOTE: The shipping brace, bolts, washers and shock sleeves should be saved and MUST be reinstalled whenever the washer is moved more than four feet. Refer to
Store the shipping materials in the accessories bag. Save materials for use whenever the washer is moved.
Reinstall front access panel.
IMPORTANT: DO NOT tip washer more than
6 inches (152.4 mm) in any direction after shipping brace has been removed. Shock absorbers may separate and damage to washer may result. For leveling purposes, the washer may be tilted a maximum of 6 inches (152.4 mm) in any direction.
1 |
|
|
|
| 2 |
|
| 3 |
| 4 | FLW2124N |
|
| |
|
| FLW2124N |
1 | Shock Sleeves |
|
2 | Motor Mount |
|
3 | Hooked End of Shipping Brace | |
4 | Bolts and Lockwashers |
|
Figure 10
Step 7: Wipe Out Inside of Wash Drum
Before using washer for the first time, use an
FLW2115N |
Figure 11
Step 8: (Supply Injection Models Only) Connect External Supplies to Washer
IMPORTANT: Undiluted chemical dripping can damage the washer.
1.Remove two nozzles from accessories bag. Use either the 3/8 inch or 1/4 inch nozzles, depending on the diameter of the dispenser tubing used.
2.Attach nozzles to rear of machine. Connection point located on cabinet, above water mixing valve. Refer to Figure 12.
3.Connect supply hoses to nozzles and secure with hose clamps (obtain locally). Refer to Figure 12.
NOTE: Hoses can be connected to either nozzle.
4.Refer to supply injection system instructions and label inside washer junction box cover (Figure 13) for electrical connection.
Do not attempt to make supply injection electrical connections to points other than those provided specifically for that purpose by the factory.
5.Refer to supply injection system instructions for details on operation.
12 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 802951 |