Alliance Laundry Systems FLW1525C manual Plug In the Washer, Electrical Requirements

Page 16

Installation

Step 9: Plug In the Washer

Electrical Requirements

(120 Volt, 60 Hertz with 3-Prong Grounding Plug)

NOTE: The wiring diagram is located in the control cabinet.

WARNING

To reduce the risk of fire, electric shock, serious injury or death, all wiring and grounding MUST conform with the latest edition of the National Electrical Code, ANSI/NFPA No. 70, and such local regulations as might apply. It is the customer’s responsibility to have the wiring, fuses and circuit breakers installed by a qualified electrician to make sure adequate electrical power is available to the washer.

W518

When plugging in the washer:

DO NOT overload circuits.

DO NOT use an extension cord.

DO NOT use an adapter.

DO NOT operate other appliances on the same circuit. Use separately fused 15 Amp circuits.

The washer is designed to be operated on a separate branch, polarized, three-wire, effectively grounded, 120 Volt, 60 Hertz, AC (alternating current), circuit protected by a 15 ampere fuse, equivalent fusetron or circuit breaker.

The three-prong grounding plug on the power cord should be plugged directly into a polarized three-slot effectively grounded receptacle rated 110/120 Volts AC (alternating current) 15 Amps. Refer to Figure 14 to determine correct polarity of the wall receptacle.

2

1 3

120±12 0 V.A.C. V.A.C.

120±12

 

 

V.A.C.

4

5

 

Standard 120 Volt, 60 Hertz

3-Wire Effectively

Grounded Circuit

DRY2022N

1L1

2Ground

3Neutral Side

4Round Grounding Prong

5Neutral

Figure 14

WARNING

To reduce the risk of an electric shock or fire, DO NOT use an extension cord or an adapter to connect the washer to the electric power source.

W082

14

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

802951

Image 16
Contents Frontload Washers Page 802951 Contents Explanation of Safety Messages Safety InformationImportant Safety Instructions Safety Information Installation Dimensions and SpecificationsBefore You Start ToolsPosition Washer Near Installation Area Installing the WasherPosition and Level the Washer Connect Fill Hoses Water SupplyConnecting Hoses Important do not cross thread or overtighten couplingsRisers Standpipe Installation Remove the Shock Sleeves and Shipping Brace Wipe Out Inside of Wash DrumControl Function Test Supply Injection SystemPlug In the Washer Electrical RequirementsCheck Installation Grounding InstructionsOperation Operation InstructionsLoad Laundry Close Loading DoorAdd Laundry Supplies Set Wash TemperatureSet Fabric Selector Set Soil Level Start WasherInsert Coins or Card To Insert MoneyIndicator Lights Insert COINS/CARDMaintenance User-Maintenance InstructionsReinstallation of Shipping Materials Cleaning Foreign Object TrapTroubleshooting Washer Symptom Possible Cause/SolutionTroubleshooting Contact Information Page Installer Checklist