Reinstallation of Shipping Materials
To prevent damage while moving the washer, the shipping materials MUST be reinstalled.
∙Disconnect washer from electrical supply.
∙While supporting the front access panel, remove two screws from the bottom edge of the panel.
∙Gently lower the panel to remove it from the washer.
∙Place the shock sleeves on all four shock absorbers. Refer to Figure 24.
∙Insert hooked end of shipping brace into the open slot of the motor mount. Refer to Figure 24.
∙Attach the brace with the five bolts and washers. Refer to Figure 24.
∙Reinstall front access panel.
1 |
|
|
|
| 2 |
|
| 3 |
| 4 | FLW2124N |
|
| |
|
| FLW2124N |
1 | Shock Sleeves |
|
2 | Motor Mount |
|
3 | Hooked End of Shipping Brace | |
4 | Bolts and Lockwashers |
|
Figure 24
Refer to Installation section, step 6 for proper procedures whenever the washer is moved.
Maintenance
Cleaning Foreign Object Trap
The washer’s pump has a trap that may collect foreign objects. The trap may need to be cleaned if water is draining slower than usual. To clean:
∙Disconnect washer from electrical supply.
∙While supporting the front access panel, remove two screws from the bottom edge of the panel.
∙Gently lower the panel to remove it from the washer.
NOTE: The pump may have some water in it. Use a rag or a container to catch water. If the wash drum is full of water, use a wet/dry shop vacuum to catch the water.
∙With rag or vacuum ready, unscrew the cap on the left side of the pump and remove trap.
∙Clean the debris from the trap.
∙Reinstall the trap and access panel.
∙Reconnect washer to electrical supply.
802951 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 21 |