Alliance Laundry Systems FLW1525C Installing the Washer, Position Washer Near Installation Area

Page 9

Installing the Washer

Step 1: Position Washer Near Installation Area

Move washer so that it is within 4 feet (1.2 meters) of the desired area of installation.

NOTE: For best performance and to minimize vibration or movement, install washer on a solid, sturdy and level floor. Some floors may need to be reinforced, especially on a second floor or over a basement. Do not install the washer on carpeting, soft tile, a platform or other weakly supported structures.

+￿,(￿$

H054I

Figure 2

Installation

Step 2: Position and Level the Washer

WARNING

Washers elevated above floor level must be anchored to that elevated surface, base or platform. The material used to elevate the washer should also be anchored to the floor to ensure that the washer will not walk or that the washer can not be physically pulled, tipped or slid from its installed position. Failure to do so may result in conditions which can produce serious injury, death and/or property damage.

W306

Position washer so it has sufficient clearance for installation and servicing.

NOTE: Use of the dispenser drawer or washer door as a handle in the transportation of the washer may cause damage to the dispenser or door.

Place washer in position on a solid, sturdy and level floor. Installing the washer on any type of carpeting, soft tile, a platform or other weakly supported structures is not recommended.

Place a level on the cabinet top and check if the washer is level from side to side and front to back.

NOTE: Level must rest on raised portion of top panel. Refer to Figure 3.

If washer is not level, tilt washer to access the front and rear leveling legs. For easier access to leveling legs, prop up washer with a wooden block. Refer to Figure 3. Loosen 7/8 in. locknut and adjust legs until the washer is level from side to side and front to back (using a level). Washer should not rock.

Tighten the locknuts securely against the washer base using the 7/8 in. wrench. If the locknuts are not tight, washer will move out of position during operation.

802951

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

7

Image 9
Contents Frontload Washers Page 802951 Contents Safety Information Explanation of Safety MessagesImportant Safety Instructions Safety Information Dimensions and Specifications InstallationTools Before You StartInstalling the Washer Position Washer Near Installation AreaPosition and Level the Washer Water Supply Connect Fill HosesImportant do not cross thread or overtighten couplings Connecting HosesRisers Standpipe Installation Wipe Out Inside of Wash Drum Remove the Shock Sleeves and Shipping BraceSupply Injection System Control Function TestElectrical Requirements Plug In the WasherGrounding Instructions Check InstallationOperation Instructions OperationLoad Laundry Close Loading DoorSet Wash Temperature Add Laundry SuppliesSet Fabric Selector Start Washer Set Soil LevelInsert Coins or Card To Insert MoneyInsert COINS/CARD Indicator LightsUser-Maintenance Instructions MaintenanceCleaning Foreign Object Trap Reinstallation of Shipping MaterialsWasher Symptom Possible Cause/Solution TroubleshootingTroubleshooting Contact Information Page Installer Checklist