Alliance Laundry Systems FLW1525C manual Connecting Hoses

Page 11

Turn on the water supply faucets and flush the lines for approximately two minutes to remove any foreign materials that could clog the screens in the water mixing valve.

NOTE: When installing in newly constructed or renovated building, it is very important to flush the lines since build-up may have occurred during construction.

Connecting Hoses

Insert each filter screen into the end of each fill hose that will connect to the water supply faucet. The screen must be facing outward. Refer to Figure 4.

Insert each plain rubber washer into the other end of each fill hose that will connect to the water mixing valve at the rear of the washer. Refer to Figure 4.

Thread hose couplings onto valve connections finger- tight, then approximately 1/4 turn with pliers.

IMPORTANT: DO NOT cross thread or overtighten couplings.

Turn water on and check for leaks. If leaks are found, retighten the hose couplings. Continue tightening and rechecking until no leaks are found.

 

 

1

 

 

COLD

 

HOT

3

 

 

 

 

2

4

 

 

 

 

TLW1976N

1

 

Faucet

2

 

Fill Hoses

3

 

Plain Rubber Washer

4

 

Filter Screens

Figure 4

Installation

IMPORTANT: Hoses and other natural rubber parts deteriorate after extended use. Hoses may develop cracks, blisters or material wear from the temperature and constant high pressure they are subjected to.

All hoses should be checked on a monthly basis for any visible signs of deterioration. Any hose showing the signs of deterioration listed above should be replaced immediately. All hoses should be replaced every five years.

 

2

3

 

1

 

 

 

WATER

4

 

MIXING

 

VALVE

 

 

FLW1974N

 

 

FLW1974N

1

Water Supply Faucets

 

2

Hot Water Connection

 

3

Cold Water Connection

 

4

Fill Hoses

 

Figure 5

IMPORTANT: Turn off water supply faucets after check-out and demonstration. Owner should turn off water supply whenever there will be an extended period of non-use.

NOTE: Longer fill hoses are available (as optional equipment at extra cost) if the hoses supplied with the washer are not long enough for the installation. Order hoses as follows:

No. 20617 Fill Hose (8 feet) (2.44 m)

No. 20618 Fill Hose (10 feet) (3.05 m)

802951

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

9

Image 11
Contents Frontload Washers Page 802951 Contents Important Safety Instructions Safety InformationExplanation of Safety Messages Safety Information Dimensions and Specifications InstallationTools Before You StartPosition and Level the Washer Installing the WasherPosition Washer Near Installation Area Water Supply Connect Fill HosesImportant do not cross thread or overtighten couplings Connecting HosesRisers Standpipe Installation Wipe Out Inside of Wash Drum Remove the Shock Sleeves and Shipping BraceSupply Injection System Control Function TestElectrical Requirements Plug In the WasherGrounding Instructions Check InstallationClose Loading Door OperationOperation Instructions Load LaundrySet Fabric Selector Set Wash TemperatureAdd Laundry Supplies To Insert Money Set Soil LevelStart Washer Insert Coins or CardInsert COINS/CARD Indicator LightsUser-Maintenance Instructions MaintenanceCleaning Foreign Object Trap Reinstallation of Shipping MaterialsWasher Symptom Possible Cause/Solution TroubleshootingTroubleshooting Contact Information Page Installer Checklist