Fisher & Paykel NZ AU PAC SG Changing pre-set options, Option adjustment mode

22

Changing pre-set options

Option adjustment mode

After using your washer a number of times you may want to fine tune some of the options to suit your wash needs.

There are a number of pre-set options, which can be altered.

In the WashSmart™ model the following pre-set options can be changed:

■■The wash temperatures.

■■The RINSE option on HEAVY DUTY and REGULAR cycles.

■■The COLD wash to CONTROLLED COLD.

■■The number of beeps at the end of the cycle.

■■The fill level selected by AUTO water level.

■■The out of balance recovery routine.

In the QuickSmart™ model the following pre-set options can be changed:

■■The WARM wash temperature.

■■The RINSE option on HEAVY DUTY, REGULAR and WOOL cycles.

■■The out of balance recovery routine.

To enter option adjustment mode

1Turn machine on at the wall but do not press POWER. Press START/PAUSE and hold down, then press POWER. You will hear two quick beeps and the machine will show an unusual pattern of lights.

In this mode the lights are used to indicate the different options available.

The diagram on page 23 shows how the lights relate to the options you can change.

Pages 24 – 26 explain the different options in more detail.

2Use the buttons on the panel to make your changes to the pre-set options.

3Press POWER to return to normal mode.

4Your washer will automatically remember your changes.

WashSmart™

Fig.33 Entering Option Adjustment mode

Note: while WashSmart™ model is shown, setting of the QuickSmart™ model is identical