26
Changing pre-set options
Out of balance recovery routine
When your washer is spinning it can sense if the wash load is out of balance. If an out of balance load is detected, the machine will stop and
Automatic recovery option
Your washer will try to automatically correct the out of balance load. It will fill with water and agitate to redistribute the load before trying to spin up again.
Machine stops option
Your washer will stop, give a short burst of beeps every five seconds, and the RINSE or SPIN light will flash. You must redistribute the load more evenly yourself (use this option if you wish to conserve water).
WashSmart™ | QuickSmart™ |
REGULAR | REGULAR |
| REGULAR | REGULAR | |
light on | light off |
| light on | light off | |
= automatic recovery | = machine stops | = automatic recovery | = machine stops | ||
Fig.38 Adjusting the Out of balance recovery routine |
|
|
| ||
Machine information |
|
|
|
| |
Specifications |
|
|
|
|
|
Model | Capacity | Depth | Width | Height* | Height (lid open) |
WA80T65G | 8.0 kg | 650 mm | 650 mm 1020 – 1050 mm | 1410 – 1440 mm | |
WA70T60G | 7.0 kg | 600 mm | 600 mm 1020 – 1050 mm | 1360 – 1390 mm | |
WA60T56G | 6.0 kg | 560 mm | 560 mm 1020 – 1050 mm | 1320 – 1350 mm | |
WA55T56G | 5.5 kg | 560 mm | 560 mm 1020 – 1050 mm | 1320 – 1350 mm | |
WA65T60M (MW613) | 6.5 kg | 600 mm | 600 mm 1020 – 1050 mm | 1360 – 1390 mm | |
MW60 | 6.0 kg | 560 mm | 560 mm 1020 – 1050 mm | 1320 – 1350 mm | |
WA55T56M (MW513) | 5.5 kg | 560 mm | 560 mm 1020 – 1050 mm | 1320 – 1350 mm | |
* Height is measured to the highest point on the console.
Note: WA10T65G, WA85T60G, WA75T56G and WA75T56M models have different capacity specifications based on country standards. Refer to the serial plate on the back of the product.
■■Electrical supply: 220 – 240 V, 50 Hz Sinusoidal, 165 W
■■Inlet water pressure: Max. 1 MPa (150 psi), Min. 34 Pa (5 psi)
■■Inlet water flow rate: Min. 3 litres/min
■■Standpipe height: 850 – 1200 mm
Note: the exact height of your washer is dependent on how far the feet are inserted into the base of the machine.