5.OPERATION
■WD-1223(5)F(H)(B) / WD-1243(5)F(H)(B)
Rinse hold
•Rinse hold function can be selected by pressing the rinse
( 
) button, and rinse hold lamp turns ON.
•Selection rinse hold washer waits without drain / spinning after rinse.
•To drain and spin, press rinse ( 
) button, rinse hold lamp turns off and drain / spinning starts.
Displaying abnormal operation
•Display the remaining time (Hour : Minute)
•The remaining time is reduced by the washing cycle.
•Error lamp is indicated the abnormal operation.
( | , | , | , | , | , | , | ) |
• Display the reservation time.
For manual wash, rinse, and spin
•Use these buttons to change washing method, rinse method spinning speed.
•When lamp is off, no selection has been made.
•Prewashing is available for coloreds, whites, and synthetic program.
Pre |
|
| 1200(1000) | 95 | T | |
R | H |
| 1000(800) | 60 | T | |
| ||||||
| 800(600) |
| ||||
| S |
| 50 |
| ||
|
|
|
| 40 |
| |
|
| 600(400) |
| |||
Main |
|
| 30 |
| ||
N |
|
| no Spin |
| ||
|
|
| Cold |
| ||
(Wash) | (Rinse) | (Spin) | (Water Temp) | (Time Delay) |
How to set the Function
How to select water temperature
•Press the button to select water temperature.
•The water temperature can be selected [40°C 50°C 60°C Cold 30°C ] during coloreds, or synthetic programs.
•95°C is selected only for whites program.
•By pressing the button while operating the present temperature is displayed.
How to use delayed washing
•Press the button when reservation washing is needed.
•When the button is pressed, 3:00 is displayed. A maximum
delay of 19:00 hours can be set.
• Whenever pressing it, one hour increases.
• Time delay the power ( | ) button to cancel it. |
•Time delay means the time required from the present to the completion of washing.
10