LG Electronics WD-102(4)1(5)W(F)(H), WD-1042FH, WD-1042F(H)(B) Error Display, Errors, Imbalance

8-4. ERROR DISPLAY.

■WD-1223(5)F(H)(B)/WD-1243(5)F(H)(B)/WD-102(4)1(5)WF(H) / WD-1041(3)F(H)B

	If you press the	Start/Pause	button when an error in displayed, any error except
	will disappear and the machine will change into pause status.
	In case of		if the error is not resolved within 20 sec. In the case of other
	errors,
	if the error is not resolved within 4 min. power will be turned off automatically and the error code will blink.
	ERROR	SYMPTOM	CAUSE
1	WATER INLET		Water has not reached to the pre-set level within 4 min. since
	ERROR	no inlet	inlet valve operated, or water has not reached to the normal
			level within 25 min.
2	IMBALANCE	imbalance	The appliance is tilted.
	ERROR		Laundry is gathered to one side.
			Non-distributable things are put into the drum.
3	DRAIN ERROR	no drain	Water has not drained enough within 5 min.
4	OVERFLOW		Water is automatically being pumped out because too much
	ERROR		water is in the tub.
5	SENSOR PRESSURE		The sensor pressure switch is out of order.
	S/W ERROR

6	DOOR OPEN	The Start/Pause	button is pressed with the door open.
	ERROR	The door switch is out of order.
7	HEATING	The thermistor is out of order.
	ERROR
8	SENSOR	The connector (5-pin, male, white) in the wire harness is not
	ERROR	connected to the connector (5-pin, female) of hall sensor in
		the MOTOR.

’Reconnect or repair the contact in the connector.

22