LG Electronics WD-1042F(H)(B), WD-1042FH, WD-1041(3)F(H)(B), WD-102(4)1(5)W(F)(H) Bad or unstable

	ERROR	SYMPTOM		CAUSE
8	SENSOR	Rinse Hold	(1000)	• The electric contact between the connectors
	ERROR		800
				(5-pin, male in the wire harness and 5-pin female in the hall sensor) is
		Super	600
		Normal	400
			no spin	bad or unstable.
		for
				Reconnect or repair the contact in the connector.
		WD-8030F(H)B / WD-8040F(H)B
		WD-1022F(H)B / WD-1042F(H)B

•The connector (6-pin, male, natural) in the wire harness is not connected to the connector (6-pin, female, natural) of PWB assembly (Main) or the electric contact of connectors is bad/unstable.

Reconnect or repair the contact in the connector.

• The electric contact between the connectors 6-pin, male in the wire harness and 6-pin female in the controller (Main) is bad or unstable.

Reconnect or repair the contact in the connector.

•The wire harness between hall sensor in the MOTOR and PWB assembly (Main) is cut (open circuited).

Repair/replace the damaged WIRE HARNESS.

•The hall sensor is out of order/defective.

Replace the motor.

•The controller (Main) is out of order/defective. Replace the PWB assembly (Main).

9	CURRENT	Pre	Rinse Hold	• PWB assembly (Main) is out of order.
	ERROR		Super	Replace the PWB assembly (Main).
		Main	Normal
				• Winding in the MOTOR is short-circuited.
		for
		WD-8030F(H)B / WD-8040F(H)B		Replace the motor.
		WD-1022F(H)B / WD-1042F(H)B
10	LOCK	(1000)	95	• The connector (3-pin, male, white) in the wire harness is not connected
			60
	ERROR	800	50	to the connector (3-pin, female, white) of MOTOR.
		600
			40	Reconnect or repair the connector.
		400	30
		no spin	Cold	• The electric contact between the connectors 3-pin, male, white in the
		for
		WD-8030F(H)B / WD-8040F(H)B		Wire Harness and 6-pin, female, white in the PWB assembly (Main)
		WD-1022F(H)B / WD-1042F(H)B
				is bad or unstable.
				Reconnect or repair the contact in the connector.

•The wire harness between the MOTOR and PWB assembly (Main) is cut (open circuited).

Repair the damaged (open-circuited) WIRE HARNESS.

•The hall sensor is out of order/defective.

Replace the PWB assembly (Main).

25