Electrolux 1271 VI manual Problem

Page 39

Something not working?

Problem

The machine does not fill

The machine fills then empties immediately

The machine does not empty and/or does not spin

There is water on the floor

Possible cause	Solution

The water tap is closed (E00).	Open the water tap.
The water inlet hose is	Check the whole length of the
squashed or kinked (E00).	hose and remove the kink.
The small filter of the water	Clean the filter.
inlet hose is clogged (E00).
The door is not properly	Close the door.
closed (E20).
The end of the drain hose	Place the hose at the right
is too low.	height (see Installation
	section).

The drain hose is	Check the whole length of
squashed or kinked (E10).	the hose and remove the
	kink.
The drain filter or the	Clean the filter or check
drain hose are clogged (E10).	the hose.
The RINSE HOLD option	Empty out the water by
(stop with water in drum)	pressing the START button
has been selected.	or selecting the PUMP OUT
	programme.
The laundry is not evenly	Redistribute the laundry
distributed inside the drum.	manually in the drum.

Too much detergent has	Measure detergent
been used.	according to the
	manufacturer’s instructions.
An unsuitable detergent	Use a suitable washing
has been used that	machine detergent.
creates too much foam.
One of the connectors on	Check that the hose is
the water inlet hose is	firmly screwed on at both
leaking.	ends.
The drain filter has not	Fully screw the filter into
been properly screwed on	place.
after cleaning.

39

Image 39

Contents ÖKO-LAVAMAT 1271 VI Turbo Dear customer Contents Programme charts Bulding-in Technical data Service & Spare Parts Guarantee ConditionsSafety instructions General safetyInstallation During use Child safetyDisposal Packaging materialsMachine Tips for environmental protection Main features of your washer-dryer Front view Description of the applianceProgramme selector dial Control panelSTART/PAUSE button Delay Start buttonON/OFF button Mains-on lightProgramme Option buttons Drying Time buttonPrewash Programme progress display DisplaySet the machine to Pause by pressing the START/PAUSE button Cancelling a programmeAltering a programme which is running Opening the door after the programme has startedBefore the first wash Detergent dispenser drawerSorting out and preparing the laundry Preparing the wash cycleCotton 40 Weight of laundryTypes of fabric and care labels CottonDelicates Which detergent? Detergents and additivesTraditional Powders Which form?As a dryer, the machine works on the condensation principle Preparing the drying cycleLoad Garments not suitable for dryingFibre residue Drying symbols on garment labelsDuration of the drying cycle Modification of the drying timeAutomatic washing and drying NON-STOP programme Additional dryingAdd detergent and additive How to washSwitching the machine on Load the laundrySpin Speed button the correspond- ing light comes on Selection of the desired wash programmeSelection of the spin speed Selection of the Extra Rinse and/or Rinse Hold optionStarting the programme Selection of the Delay Start optionAt the end of the programme NON-STOP programme How to dryAutomatic washing and drying Drying onlyWash programmes Programme chartAdditional Max Duration Dry Special programmesDrying Detergent dispenser drawer Cleaning and maintenancePeriodical cleaning Exterior After each washWater inlet filter Drain filterEmergency emptying out Frost precautionsSomething not working? TroubleshootingProblem Noisy Feet have not been E00 White residue is left on the laundry Unsatisfactory washing resultsIf grey stains remain on the laundry Foam is still visible even after the last rinseThis appliance complies with the following EC directives Technical dataHelp us to help you Service & Spare PartsService & Spare Parts 0990 929Customer care Guarantee Conditions Italy Pordenone +39 1678 Sweden Stockholm +46 738 Slough +44 European GuaranteeSafety instructions for the installer Instructions for installation and electrical connectionRear view Front view and side viewTic bag and the previously removed screw InstallationUnpacking Carefully slide out the right poly- thene bagCarefully level by screwing PositioningLevelling Set the machineWater inlet cold water connection only Water drainageDo not connect to a hot water supply Electrical connections Interest of the environmentPermanent connection Hinges Preparation and assembly of the doorBuilding-in DoorCounter-magnet Mounting the doorSee Fig. H Drill four fixing holes see Fig. GBuilding-in