Electrolux LAVAMAT 14800, OKO-Lavamat 16800, Lavamat 14800 manual Problem, Possible cause Solution

Page 38

Something not working?

Problem

The machine does not fill

The machine fills then empties immediately

The machine does not empty and/or does not spin

There is water on the floor

Possible cause

Solution

 

 

The water tap is closed (E10).

Open the water tap.

The water inlet hose is

Check the whole length of the

squashed or kinked (E10).

hose and remove the kink.

The small filter of the water

Clean the filter.

inlet hose is clogged (E10).

 

The door is not properly

Close the door.

closed (E40).

 

The end of the drain hose

Place the hose at the right

is too low.

height (see Installation

 

section).

 

 

The drain hose is

Check the whole length of

squashed or kinked (E20).

the hose and remove the

 

kink.

The drain filter or the

Clean the filter or check

drain hose are clogged (E20). the hose.

The RINSE HOLD option

Empty out the water by

(stop with water in drum)

pressing the START button

has been selected.

or selecting the DRAIN

 

programme.

The laundry is not evenly

Redistribute the laundry

distributed inside the drum.

manually in the drum.

 

 

Too much detergent has

Measure detergent

been used.

according to the

 

manufacturer’s instructions.

An unsuitable detergent

Use a suitable washing

has been used that

machine detergent.

creates too much foam.

 

One of the connectors on

Check that the hose is

the water inlet hose is

firmly screwed on at both

leaking.

ends.

The drain filter has not

Fully screw the filter into

been properly screwed on

place.

after cleaning.

 

38

Image 38
Contents Turbo Electronic Dear customer Contents Programme charts wash and special programmes Automatic washing and drying NON-STOP programmePage Installation Safety instructionsGeneral safety Child safety During usePackaging materials DisposalTips for environmental protection MachineMain features of your washer-dryer Description of the appliance Front viewControl panel Programme selector dialDelayed Start button START/PAUSE buttonProgramme Option buttons Electronic Drying button Store DRYDrying Time button Prewash Display Programme progress displayOpening the door after the programme has started Cancelling a programmeAltering a programme which is running Detergent dispenser drawer Before the first washPreparing the wash cycle Sorting out and preparing the laundryCotton Sort of laundry Approximate Dry weightsTypes of fabric and care labels SyntheticsDelicates 40 Detergents and additives Which detergent?Which form? Traditional PowdersGarments not suitable for drying Preparing the drying cycleLoad Modification of the drying time or degree of drying Drying symbols on garment labelsDuration of the drying cycle Fibre residueLoad the laundry How to washMax. load Add detergent and additiveSelection of the desired wash programme Selection of the desired optionsSelection of the Delayed Start option Selection of the Extra Rinse optionStarting the programme DownAt the end of the programme NON-STOP programme How to dryAutomatic washing and drying Drying only Max. loadProgramme chart Wash programmesMax Consumption Tion Special programmesDescrip Consumption data for timed drying Timed DryingPeriodical cleaning Exterior Cleaning and maintenanceMaintenance Wash After each washDoor seal Drain filterEmergency emptying out Frost precautionsWater inlet filter Something not working? TroubleshootingProblem Possible cause Solution Problem Possible cause SolutionNoisy Feet have not been Problem Possible cause E10Foam is still visible even after the last rinse Unsatisfactory washing resultsIf grey stains remain on the laundry White residue is left on the laundryTechnical data This appliance complies with the following EC directives08705 929 Service & Spare PartsService & Spare Parts Help us to help youCustomer care Guarantee Conditions European Guarantee Instructions for installation and electrical connection Safety instructions for the installerDimensions of the appliance Front view and side viewInstallation UnpackingLevelling Installation on a suspended floorPositioning Water inlet cold water connection onlyWater drainage Do not connect to a hot water supply ModelInterest of the environment Electrical connections Remove the fuse from the cut off plugPermanent connection