Installation
Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.
Do not connect to a hot water supply.
Model 16800
The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to natural ageing of the hose. This fault is shown by a red sector in
the window “A”. Should this occur, turn the A water tap off and refer to your Service Force Centre to replace the hose.
Water drainage
The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic
When discharging into a stand- pipe ensure that the top of the curve in the hose end is no more than 90 cm (35.4”) and no less than 60 cm (23.6”) above floor level.
3 pin
Max. 90 cm.(35.4")
Min.60 cm.(23.6")
The upright standpipe should have a mini- mum length of 30 cm (12”) from the bottom of the elbow to the top of the pipe (see dia- gram). Make sure that it is designed in such a way that the end of the drain hose cannot be covered with water.
Min. 30 cm.(12")
38mm.(1/2") diameter standpipe
51