Servis WD1496FGS, WD1496FGW, WD1496FGB Installation Requirements, Removal of Transit Bolts

INSTALLATION

INSTALLATION REQUIREMENTS

To avoid risk of injury, please take care when moving your Washer Dryer. It is heavy and we recommend that a minimum of two people move your Washer Dryer.

To unpack your Washer Dryer and manoeuvre it to the installation area, one person should hold it by the front feet and the other person at the edge of the lid at the rear.

Your Washer Dryer measures 84.5 x 59.7 x 58.2cm and will require an installation area with the space to allow the door to fully open and provide easy access to the plumbing and electrical connections.

The most suitable installation surface for your Washer Dryer is a concrete floor as it is less prone to vibration during the spin cycle. Soft floor surfaces such as carpets and rugs are not suitable.

If you have to install your Washer Dryer on a wooden floor, we recommend that a water- resistant wooden base at least 30mm thick is installed. The base should span several joists and be bolted down. Check for the presence of pipes and cables before installing.

If possible, install your Washer Dryer in the corner of the room as it is often the most stable part of the floor.

Do not install your Washer Dryer in rooms where temperatures below freezing may occur as frozen hoses may burst or split.

REMOVAL OF TRANSIT BOLTS

The transit bolts are used to protect your Washer Dryer from damage during transportation and must be removed before using your Washer Dryer for the first time. Keep the transit bolts safe and re-fit them if you need to transport your Washer Dryer in the future.

The four transit bolts are located on the back of your Washer Dryer (fig 5a). To remove the transit bolts (4 off):

1Remove each bolt by turning anti-clockwise with a suitable spanner (fig 5b).

11 T: 0800 0124 382

2Pull out the remaining plastic section of each transit bolt by hand. This will require a reasonable amount of force (fig 5c).

3Insert the blanking caps (4 off): Push the cap into the hole until the four connectors click into place. Check that the cap is flush with the Washer Dryer.

a:b:

c:

Figure 5

To re-fit the transit bolts (4 off) for future transportation:

1Pull and remove the four plastic blanking caps.

2Insert the plastic sections of the transit bolts into the exposed holes.

3Insert the bolts into the plastic sections of the transit bolts and tighten with a suitable spanner until secure.

T: 0800 0124 382 12