INSTALLATION 
ADJUSTING THE FEET 
For safe operation, it is important that your Washer Dryer is level and securely positioned on all four feet. Incorrect installation may cause the Washer Dryer to vibrate and increase your water and electricity consumption. Never place cardboard, wood or similar materials under your Washer Dryer to increase stability.
The four adjustable feet are used to level the Washer Dryer. To adjust the feet:
1Loosen the plastic locking nut by turning
2To increase the height of the machine, turn the feet
3To decrease the height of the machine, turn the feet clockwise (fig 6b).
4After making adjustments, use a spirit level to check that the machine is level.
5Once the machine is level, tighten the locking nuts by turning clockwise (fig 6c).
a:b:
c:
Figure 6
13 T: 0800 0124 382
WATER SUPPLY CONNECTION 
Your Washer Dryer uses an energy efficient cold fill system, which means that only the water required to wash the laundry is heated. As a result, no heat is lost in the pipeline from the hot water supply.
Connect your Washer Dryer to your cold water supply only. If your previous machine had a hot and cold fill, check that the hot tap on your water supply is closed to avoid leakage. Only use the fill hose supplied and not one from your old Washer Dryer. Only one hose is required to install your Washer Dryer to the cold water supply. The inlet hose provided with your Washer Dryer connects the rear of your machine and the cold water supply.
To connect your Washer Dryer to the cold water supply:
1Connect the angled end of the fill hose to the cold water inlet on the rear of your Washer Dryer by screwing the threaded connector clockwise (fig 7). Take care not to overtighten the connection. Hand tight is sufficient.
Figure 7
T: 0800 0124 382 14