Troubleshooting Procedures
!WARNING
To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing requires power.
•Disconnect inlet hoses from the Water Valve and clean the valve screens of any debris.
Noisy and/or Vibration/Walking
•Check if the washer was properly leveled and the locking nuts are securely tightened up against the base frame of the washer.
•Check and determine all four of the shipping bolts and spacers have been fully removed from the rear panel of the washer.
•Check for proper load size and distribution. If clothes load is too small, add a few towels to balance the clothes load better.
•Check the tightness of the rear pulley bolt. Tighten if necessary.
•Clean floor and bottom side of washer feet. Check clearance. Refer to the back of machine and Installation Instruction.
Rubber Feet Leaving Marks on Floor
•Use a pencil eraser to remove mark.
•Walk washer into location, do not drag.
Additive Cups Full of Water
•Small amount of water in bottom of additive cups is normal.
•Remove and wash Dispenser Tray, removable Cup, and Rinse Cap.
•Level washer.
Buttons do not Respond
•Option and Function buttons respond differently according to each cycle.
•Child Lock feature has been selected. To disable feature press and hold Wash/Rinse Temp and Spin Speed simultaneously until a beep is heard.
•When display shows "End", only the Power Off button will function. Press Power Off and make new cycle selections.
Consumer Information Codes
If the consumer observes codes on display, see table below.
LED | Description | Diagnostic | |
Display |
| code | |
|
|
| |
| The water level |
| |
| fails to drop |
| |
nd | below the Low |
| |
Water level reset | 1 | ||
| within 15 |
| |
| minutes, before a |
| |
| spin begins. |
| |
|
|
| |
| Door failed to |
| |
LO | unlock after 3 | 2 | |
| attempts. |
| |
nF | Continuous fill of |
| |
| |||
12minutes. Total | 3 | ||
| fill of 14minutes. |
| |
|
|
| |
| Door failed to |
| |
FL | lock after3 | 4 | |
| attempts. |
| |
LE | Water sensor | 8 | |
level fault. | |||
|
| ||
|
|
| |
| A fault is |
| |
| detected in the |
| |
| water level |
| |
OE | sensor. Data |
| |
(frequency) | E | ||
| shows the water |
| |
| level is at or |
| |
| above the |
| |
| overflow level. |
| |
|
|
| |
| Detected a key |
| |
|
| ||
| pressed more |
| |
E2 | than 30seconds, | 15 | |
the key will be | |||
|
| ||
| assumed to be |
| |
| stuck. |
| |
|
|
| |
| Never exceeded |
| |
|
| ||
dc | 400rpm due to | 10 | |
an unbalanced | |||
|
| ||
| load. |
| |
| The door has not |
| |
| been opened |
| |
| after two |
| |
od | complete wash |
| |
cycles. Door | 17 | ||
| switch was not |
| |
| seen open since |
| |
| the last two final |
| |
| spins. |
| |
|
|
|
12 | 16025909 Rev. 0 | ©2005 Maytag Services |