Maytag MAH9700AW* manual Disassembly Procedures

Page 34

Disassembly Procedures

!WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power to unit before servicing.

5. Remove 19mm nut .

NOTE: When reinstalling Motor torqe nut to 32-47 ft. lbs.

6.Grasp the Rotor at 3 and 9 o’clock while pulling Rotor from shaft.

CAUTION: The rotor contains powerful magnets. Use caution during handeling and installation. DO NOT place fingers between rotor and windings during installation.

7.Depress and release latch to remove motor wiring connectors.

7.Depress and release latch to remove motor wiring connectors.

8.Remove the six 10mm bolts securing stator coil to the tub.

NOTE: There are alignment pins for the Stator reinstallation. Use caution during removal and installtion, the stastor will not hang from the alignment pins. Start a screw while supporting the Stator with the other hand.

34	16025909 Rev. 0

©2005 Maytag Services

Image 34

Contents Service Important Notices for Servicers and Consumers General Information Important Safety Information Neutral Side GroundNeutral Round GroundingGrounding Instructions Important Safety Information General Information H 9 No Tumble Will Not StartLeaking Will Not SpinSee Will Not Spin Wrong Water TemperatureWet Clothes Will Not LockDescription Diagnostic Display Code Consumer Information CodesHolds During test Cancels hold Predefined Resumes next Enter / Exit Service ModeService Mode Hold Quick Press Rotary Spin StepHold Quick Spin Step Board Input Test Diagnostic Code Display InitialQuick Spin Test OutputSwitch Action Quick Service CycleLED/Switch Test Fast Time Down TestSelection Function Display Board Output TestSelection Component Function Go to Will Not Display Diagnostic CodesDiagnostic Codes Description Trigger Action to be Taken DrainDiagnostic codes Diag Description Trigger Action to be Code TakenOutput Test Exit Service ModeDiag Description Trigger Action to be Diag Description Trigger Action to be CodeComponent Testing Information CN3 CN6 CN9 CN8 CN7 Water flow through dispenser during Wash fill Water flow through dispenser during Rinse 1 fill Water flow through dispenser during Rinse 2 fill Disassembly Procedures Disassembly Procedures Water Valve Removal Door Removal Disassembly Procedures Front Panel Removal Heater Removal Motor Removal Disassembly Procedures Drain Pump Removal 1x12 32 long Disassembly Procedures Disassembly Procedures Disassembly Procedures Disassembly Procedures Appendix a DC68-02032B 16025909 Rev WA Rning Location Considerations 16025909 Rev 16025909 Rev 16025909 Rev Appendix B 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev Roubleshooting 16025909 Rev