Troubleshooting Procedures
!WARNING
To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing requires power.
Test or Display
Fast
Time-
Down / Advance to Next Step
Quick
Service
Cycle
Hold Quick
Service Cycle
Step
LED/Switch
Test
Press LED to | Press LED to |
Start | Cancel |
Press | Press Power |
Temperature | Off |
to start test. |
|
Press |
|
Temperature |
|
during cycle to |
|
advance. |
|
Press | Press Off (also |
Temperature | exits Service |
and Soil Level | Mode) |
Press | Press |
Rinse&Spin | Rinse&Spin |
and Spin Only | and Spin Only |
together | to resume |
Press Delay for | Press Off twice |
3 seconds (then | after starting |
individual | test |
buttons to test) |
|
Rotate Cycle |
|
Selector |
|
clockwise, the |
|
LED’s around it |
|
will be toggled. |
|
Test or Display
All Diagnostic Codes
Cycle Count No. for Diagnostic Code
Clear All
Diagnostic
Codes
Display
Software
Version
Cycle Count
Press LED to | Press LED to |
Start | Cancel |
Rotate Cycle | N/A |
Selector either |
|
direction |
|
Press and hold | Release Rotary |
Rotary | Selector |
Selector, while | (returns to |
diagnostic code | diagnostic code |
is displayed | display) |
Press Delay |
|
and Chime |
|
together while |
|
displaying |
|
diagnostic |
|
codes |
|
Press Soil | Press Soil |
Level. Press 2 | Level a 3rd time |
times for |
|
displays with |
|
only 2 character |
|
positions. |
|
Press Chime |
|
Rotate |
counterclockwis |
e, the7- |
segment LED’s |
toggle. Press |
Rotary Cycle |
Selector, all of |
the LED’s |
around the |
Rotary Cycle |
Quick Spin Test
While in Service Mode, press Delay and Rinse&Spin keys to start a Quick Spin Test. Quick Spin test steps are as follows:
•Start spinning and after reaching a maximum spin speed.
•stay at maximum spin speed for 2 minutes and stop Quick Spin Test.
Hold Quick Spin Step
IN 
Board
Input
Test
Selector will be |
|
toggled. |
|
Press Spin | Press Spin |
Only | Only |
If the Rotary Selector key is pressed during the Quick Spin test, the machine will hold at the next highest index speed for up to 10 minutes. At the end of 10 minutes, the machine will resume and finish the Quick Spin test. To cancel the Hold and allow the
Board |
Output |
Test / |
System Check |
Diagnostic Code Display (Initial)
Press Spin | Press Off |
Speed |
|
Press Rinse& | Press |
Spin – displays | Rinse&Spin |
“d” | again |
Spin Test to continue, press the Delay and Rinse&Spin keys.
14 | 16025909 Rev. 0 | ©2005 Maytag Services |