Maytag MAH9700AW* manual Location Considerations

Page 45

To Avoid The Possibility Of Water Damage:

•Have Water Faucets Easily Accessible

•Turn Off Faucets When Washer Is Not In Use.

DRAIN FACILITY

Recommendedheight of the standpipe is 18”. The drain hose must be routed through the drain hose clip to the standpipe. Standpipe must be large enough to acceptthe outside diameter of the drain hose. The drain hose is attachedat the factory.

FLOORING

For best performancethe washer must be installed on a solidly constructed floor. Wood floors may need to be reinforced to minimize vibration and/or unbalancedload situations. Carpeting and soft tile surfaces are contributing factors in vibration and/or tendency for a washer to move slightly during the spin cycle. Never install the washer on a platform or weakly supported structure.

LOCATION CONSIDERATIONS

It is recommendedthe washer never be installed in areas where water may freeze since the washer will always maintain some water in the water valve, pump and hose areas. This can cause damageto belts, pump, hoses and other components.Operating temperature should be above 60°F.

ALCOVE OR CLOSET INSTALLATION

MINIMUM CLEARANCES FOR CLOSET AND ALCOVE INSTALLATIONS:

Sides – 0 in / 0 mm Rear – 1 in / mm

Top – 2 in / mm Closet Front – 0 in / 0 mm

The closet front must have a total unobstructed air opening of 72 in2. / 465 cm2 minimum, if both washer and dryer are installed together. A louvered door with equivalent air opening is acceptable.Washer alone does not require specific air opening.

©2005 Maytag Services

16025909 Rev. 0

45

Page 44 Page 46
Image 45
Page 44 Page 46
Contents Service Important Notices for Servicers and Consumers General Information Important Safety Information Neutral GroundNeutral Side Round GroundingGrounding Instructions Important Safety Information General Information H 9 Leaking Will Not StartNo Tumble Will Not SpinWet Clothes Wrong Water TemperatureSee Will Not Spin Will Not LockConsumer Information Codes Description Diagnostic Display CodeService Mode Enter / Exit Service ModeHolds During test Cancels hold Predefined Resumes next Hold Quick Press Rotary Spin StepQuick Spin Test Diagnostic Code Display InitialHold Quick Spin Step Board Input Test OutputLED/Switch Test Quick Service CycleSwitch Action Fast Time Down TestBoard Output Test Selection Function DisplaySelection Component Function Diagnostic Codes Description Trigger Action to be Taken Display Diagnostic CodesGo to Will Not DrainDiag Description Trigger Action to be Code Taken Diagnostic codesDiag Description Trigger Action to be Exit Service ModeOutput Test Diag Description Trigger Action to be CodeComponent Testing Information CN3 CN6 CN9 CN8 CN7 Water flow through dispenser during Wash fill Water flow through dispenser during Rinse 1 fill Water flow through dispenser during Rinse 2 fill Disassembly Procedures Disassembly Procedures Water Valve Removal Door Removal Disassembly Procedures Front Panel Removal Heater Removal Motor Removal Disassembly Procedures Drain Pump Removal 1x12 32 long Disassembly Procedures Disassembly Procedures Disassembly Procedures Disassembly Procedures Appendix a DC68-02032B 16025909 Rev WA Rning Location Considerations 16025909 Rev 16025909 Rev 16025909 Rev Appendix B 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev Roubleshooting 16025909 Rev
Top Page Image Contents