Maytag MAH9700AW* manual Diag Description Trigger Action to be Code Taken, Diagnostic codes

Troubleshooting Procedures

!WARNING

To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing requires power.

Diag.	Description	Trigger	Action to be
Code			taken
		Input signal
		from water
		level Sensor	Displays "LE"
	Water level	is out of
8		range,	Go to “No water fill
	sensor fault.
		Washer will	Troubleshooting”.
		beep and
		pause the
		wash cycle.
9		Not Used
	Unbalance
	detected	Never	LED – Will display
	during final
		exceeded
	spin, which		“dc”
10		400rpm due
	prevented	to an	Go to "Wet Clothes
	the spinner		"Troubleshooting
		unbalance
	from		Section"
		load.
	exceeding
	400 rpm
		Water level in
		the machine
		is believed to
		be above the
		overflow level.
		When this
		condition is	First check to see
	Water	detected, the	that water valve is
E	sensor level	machine will	not stuck. If water
	fault.	automatically	valve is OK, check
		begin	water level sensor
		pumping
		water out of
		the machine
		until it falls
		below the
		overflow level.
			Go to "Clear
			diagnostic codes"
			Disconnect and
	Will not	Difficulty in	reconnect the
			washer power cord
	remember
11		reading	at power supply
	machine
		memory	outlet.
	settings
			If condition still
			exists, replace
			machine control
			board.

Diag.	Description	Trigger	Action to be
Code			taken
		A key is	Display "E2". Go to
		sensed to be	"Membrane Pad
		pressed more	Check" Check
15	Stuck Key	than 30	connection of
		seconds, the	keypad to control
		key will be	board. Replace
		assumed to	LED Board if
		be stuck	necessary.
		The door has
		not been
	Door switch	opened after
	was not	two complete	Will display "od" If
17	seen open	wash cycles.	door open sensing,
	since the last	Door switch	will cleared.
	three final	was not seen
	spins	open since
		the last two
		final spins
			Check for loose
			wire connections
			Clear the diagnostic
	Detected		code and recheck;
	door lock	Open door	if reoccurs, perform
18	switch open	lock switch	Diagnostic
	during cycle	with motor	Motor/Machine
	when not	running.	Control Board test
	expected.		Check for faulty
			motor relay on the
			machine control
			board.
19-21		Not Used
	Door switch	Door switch is	Go to "Door Lock
		detected open
	detected	and the door	Test"
22	open during
	cycle (when	locked switch	Troubleshooting
	not paused).	is read as	Section
		locked.
23-24		Not Used

12-14

Not Used

©2005 Maytag Services 16025909 Rev. 0 19