Maytag MAH9700AW* manual 1x12 32 long

Page 36

Disassembly Procedures

!WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power to unit before servicing.

Outer Tub and Spinner Removal

1.Disconnect power supply to unit.

2.Remove Top Cover.

3.Remove Console.

4.Remove Front Panel.

5. Remove Back Cover.

6.Remove Pump Hose.

7.Remove the Drain Hose

8.Remove the two 13mm bolts securing the Rear Struts to the base.

NOTE: Torque bolts to 11-22 ft lbs. during installtion.

11. Remove wire harness connectors for the heater, Themistor and ground.

12.Remove two 13mm bolts securing the Front Struts to base and rotate up against the bottom of the tub.

13.Insert a board or boards across the bottom of the washer frame to use as a support when removing the tub assembly.

9.Rotate the struts up against the bottom of the tub to ease removal of the tub assembly.

1x12 - 32” long

NOTE: The rear struts can be identified by the green sleeve.

10.Remove two each side 13mm bolts securing Counter Weights.

36	16025909 Rev. 0

©2005 Maytag Services

Image 36

Contents Service Important Notices for Servicers and Consumers General Information Important Safety Information Ground NeutralNeutral Side Round GroundingGrounding Instructions Important Safety Information General Information H 9 Will Not Start LeakingNo Tumble Will Not SpinWrong Water Temperature Wet ClothesSee Will Not Spin Will Not LockDescription Diagnostic Display Code Consumer Information CodesEnter / Exit Service Mode Service ModeHolds During test Cancels hold Predefined Resumes next Hold Quick Press Rotary Spin StepDiagnostic Code Display Initial Quick Spin TestHold Quick Spin Step Board Input Test OutputQuick Service Cycle LED/Switch TestSwitch Action Fast Time Down TestSelection Function Display Board Output TestSelection Component Function Display Diagnostic Codes Diagnostic Codes Description Trigger Action to be TakenGo to Will Not DrainDiagnostic codes Diag Description Trigger Action to be Code TakenExit Service Mode Diag Description Trigger Action to beOutput Test Diag Description Trigger Action to be CodeComponent Testing Information CN3 CN6 CN9 CN8 CN7 Water flow through dispenser during Wash fill Water flow through dispenser during Rinse 1 fill Water flow through dispenser during Rinse 2 fill Disassembly Procedures Disassembly Procedures Water Valve Removal Door Removal Disassembly Procedures Front Panel Removal Heater Removal Motor Removal Disassembly Procedures Drain Pump Removal 1x12 32 long Disassembly Procedures Disassembly Procedures Disassembly Procedures Disassembly Procedures Appendix a DC68-02032B 16025909 Rev WA Rning Location Considerations 16025909 Rev 16025909 Rev 16025909 Rev Appendix B 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev 16025909 Rev Roubleshooting 16025909 Rev