Electrolux 58840R user manual Long anti-crease phase lengthen the anti

Page 19

Daily use 19

LONG ANTI-CREASE

A long anti-crease phase lengthen the anti-

crease phase (30 min.) at the end of the drying additionally by 60 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. Phase lasts

in total 90 minutes. The laundry can be re- moved at any time during the anti-crease phase.

When the option is active, the LONG ANTI-CREASE icon is on.

SENSITIVE

For gentle drying of fabrics that are frequently worn. Programme starts on full heat setting, which is then reduced as the programme progresses to be kind to the washing.

When the option is active, the SENSITIVE icon is on.

BUZZER

The appliance is supplied with the BUZZER function deactivated.

To activate buzzer choose BUZZER option.

When the option is active, the BUZZER icon is on.

The buzzer sounds or plays a tune during:

– cycle end

–anti-crease phase and when phase starts or ends

–cycle interruption by a warning

–alarm

Image 19

Contents Lavatherm 58840R Dear Customer Contents Service General safety Important safety informationInstallation Use Child safetyProduct description Control panel Sorting laundry What is shown in the displayBefore first use Sorting and preparing laundryPreparing laundry RPMT/MIN Programme overviewLichte Strijken WOL Selecting the programme Switching machine on / switching light onDaily use Opening loading door / loading laundryIf the washing in the washing machine was Setting dryness levelSetting the pre-drainage spin speed Selecting additional optionsFor especially gentle drying of sensitive fab DelicateWhen the option is active, the Sensitive icon is on Long anti-crease phase lengthen the antiSetting child lock Setting delay timerTime Changing programme Starting the programmeOpen door Drying cycle complete / removing laundryClose the door Drying rack Min, from 30 min. up to 180 minutes Cleaning fluff filter Care and cleaningAfter cleaning do not forget to put it back Clean the entire filter area Emptying the condensate tank Cleaning the door sealEmpty condensate tank after every drying cycle Drying cycle Cleaning heat exchangerCare and cleaning Turn both lock washers inwards Cleaning the drumClean operating screen and housing What to do if Troubleshooting by yourselfStart Pauze button Replace defective bulb Screw cover back down Changing the bulb for interior lightingSetting Implementation Buzzer permanent off Machine settingsConsumption values Technical dataCotton cycle with nominal and half load InstallationHints for test institutes Appliance positioningDrying rack unpacking Removing transport safety packagingFor easiest unpacking turn the rack upside down Electrical connectionChanging door stop Remove the elastic band fixing the rack handle to containerPage Intermediate installation kit for stacked washer and dryer Special accessoriesPackaging material EnvironmentOld appliance Pre-draining Drying cycle Environmental tipsService Subject to change without notice