Electrolux 58840R Special accessories, Intermediate installation kit for stacked washer and dryer

Page 40

40Installation

7.Unscrew cover plates E from the front of the machine, rotate through 180°, screw on the oppo- site side.

8.Unscrew door lock F, push down slightly and remove from the front of the machine.

9.Disconnect cable connector from door lock F.

10.Press snap-in button G in and down, press cover down slightly and remove from front of the ma- chine.

11.Disconnect cable connector from cover G.

E

 

 

G

F

 

E

 

F

G

 

12.Change door lock F over to the opposite side, insert the cable connector and screw down the door interlock.

13.On the other side, insert the cable connector in cover G, insert cover and allow snap-in button to lock into place.

14.Insert loading door and hinges into recesses on the front of the machine and screw down.

Note regarding contact protection:The machine is only secure for operations again once all plastic parts have been inserted.

Special accessories

Intermediate installation kit for stacked washer and dryer:

Available from your Service Force Centre or your specialist dealer

These intermediate installation kits can be used to arrange the dryer and an automatic AEG-Electrolux washing machine (60cm wide, front loading) as a space- saving washer/dryer stack. The automatic washing machine is at the bottom and the dryer is at the top.

Version to be supplied:

– with extractable stacker plate 916.018 903

Read carefully the instructions supplied with the kit.

Image 40
Contents Lavatherm 58840R Dear Customer Contents Service Important safety information General safetyInstallation Child safety UseProduct description Control panel What is shown in the display Before first useSorting and preparing laundry Sorting laundryPreparing laundry Programme overview RPMT/MINLichte Strijken WOL Switching machine on / switching light on Daily useOpening loading door / loading laundry Selecting the programmeSetting dryness level Setting the pre-drainage spin speedSelecting additional options If the washing in the washing machine wasDelicate For especially gentle drying of sensitive fabLong anti-crease phase lengthen the anti When the option is active, the Sensitive icon is onSetting child lock Setting delay timerTime Starting the programme Changing programmeOpen door Drying cycle complete / removing laundryClose the door Drying rack Min, from 30 min. up to 180 minutes Cleaning fluff filter Care and cleaningAfter cleaning do not forget to put it back Clean the entire filter area Emptying the condensate tank Cleaning the door sealEmpty condensate tank after every drying cycle Cleaning heat exchanger Drying cycleCleaning the drum Care and cleaning Turn both lock washers inwardsClean operating screen and housing Troubleshooting by yourself What to do ifStart Pauze button Changing the bulb for interior lighting Replace defective bulb Screw cover back downMachine settings Setting Implementation Buzzer permanent offTechnical data Consumption valuesInstallation Hints for test institutesAppliance positioning Cotton cycle with nominal and half loadRemoving transport safety packaging Drying rack unpackingElectrical connection Changing door stopRemove the elastic band fixing the rack handle to container For easiest unpacking turn the rack upside downPage Special accessories Intermediate installation kit for stacked washer and dryerPackaging material EnvironmentOld appliance Environmental tips Pre-draining Drying cycleService Subject to change without notice