Electrolux 58840R user manual Starting the programme, Changing programme

Page 21

Daily use 21

all buttons and the programme knob. The child lock can be activated or deactivated by holding down the OPTION OPTIE and OK buttons simultaneously for 5 seconds.

– Before programme is started: Appliance cannot be used

– After programme is started: Programme in operation cannot be changed

The icon appears in the display to indicate that the child safety device is activated.

The child safety device is not deactivated once the programme comes to an end.

If you want to set a new programme, you must first deactivate the child safety device.

Starting the programme

Press the START PAUSE START PAUZE button. The programme is started.

The programme progress is shown in LCD by appropriate set of icons. From left to the right, from IRON DRY to ANTI-CREASE icon depends on the drying cycle chosen. E. g. in case of CUPBOARD programme the following

status icons are visible:

.

Current cycle progress is marked by flashing dash under status icon. When appro- priate part of drying cycle is accomplished dash becomes steady and appears flashing under next status icon.

Changing programme

To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF UIT and then reset the pro- gramme.

The programme can no longer be changed directly once the programme has started. If nevertheless there is an attempt to change the programme on the programme knob, the programme progress display and the maintenance indicators flash. If an option button (excluding the BUZZER option) is pressed, Err appears in the multi- display. The drying programme is not however affected by this (laundry protection).

Image 21

Contents Lavatherm 58840R Dear Customer Contents Service General safety Important safety informationInstallation Use Child safetyProduct description Control panel Before first use What is shown in the displaySorting and preparing laundry Sorting laundryPreparing laundry RPMT/MIN Programme overviewLichte Strijken WOL Daily use Switching machine on / switching light onOpening loading door / loading laundry Selecting the programmeSetting the pre-drainage spin speed Setting dryness levelSelecting additional options If the washing in the washing machine wasFor especially gentle drying of sensitive fab DelicateWhen the option is active, the Sensitive icon is on Long anti-crease phase lengthen the antiSetting delay timer Setting child lockTime Changing programme Starting the programmeDrying cycle complete / removing laundry Open doorClose the door Drying rack Min, from 30 min. up to 180 minutes Care and cleaning Cleaning fluff filterAfter cleaning do not forget to put it back Clean the entire filter area Cleaning the door seal Emptying the condensate tankEmpty condensate tank after every drying cycle Drying cycle Cleaning heat exchangerCare and cleaning Turn both lock washers inwards Cleaning the drumClean operating screen and housing What to do if Troubleshooting by yourselfStart Pauze button Replace defective bulb Screw cover back down Changing the bulb for interior lightingSetting Implementation Buzzer permanent off Machine settingsConsumption values Technical dataHints for test institutes InstallationAppliance positioning Cotton cycle with nominal and half loadDrying rack unpacking Removing transport safety packagingChanging door stop Electrical connectionRemove the elastic band fixing the rack handle to container For easiest unpacking turn the rack upside downPage Intermediate installation kit for stacked washer and dryer Special accessoriesEnvironment Packaging materialOld appliance Pre-draining Drying cycle Environmental tipsService Subject to change without notice