Electrolux 58840R user manual Cleaning the door seal, Emptying the condensate tank

Page 27

Care and cleaning 27

If the fine strainer is not fitted, the large mesh filter will not snap into place and the loading door cannot be closed.

Cleaning the door seal

Wipe the door seal with a damp cloth immediately after the drying cycle has finished.

Emptying the condensate tank

Empty condensate tank after every drying cycle.

If the condensate tank is full, an active programme will break off automatically and the EMPTY CONTAINER icon on the display will light up. In order to continue the programme, the condensate tank must first be emptied.

WARNING!

The condensate is not suitable for drinking or for preparing foodstuffs.

1.Take out drawer containing con- densed water container completely 1 and pull up the condensed water container’s drainage pipe as far as it will go 2.

2

1

Image 27
Contents Lavatherm 58840R Dear Customer Contents Service General safety Important safety informationInstallation Use Child safetyProduct description Control panel Sorting laundry What is shown in the displayBefore first use Sorting and preparing laundryPreparing laundry RPMT/MIN Programme overviewLichte Strijken WOL Selecting the programme Switching machine on / switching light onDaily use Opening loading door / loading laundryIf the washing in the washing machine was Setting dryness levelSetting the pre-drainage spin speed Selecting additional optionsFor especially gentle drying of sensitive fab DelicateWhen the option is active, the Sensitive icon is on Long anti-crease phase lengthen the antiSetting delay timer Setting child lockTime Changing programme Starting the programmeDrying cycle complete / removing laundry Open doorClose the door Drying rack Min, from 30 min. up to 180 minutes Care and cleaning Cleaning fluff filterAfter cleaning do not forget to put it back Clean the entire filter area Cleaning the door seal Emptying the condensate tankEmpty condensate tank after every drying cycle Drying cycle Cleaning heat exchangerCare and cleaning Turn both lock washers inwards Cleaning the drumClean operating screen and housing What to do if Troubleshooting by yourselfStart Pauze button Replace defective bulb Screw cover back down Changing the bulb for interior lightingSetting Implementation Buzzer permanent off Machine settingsConsumption values Technical dataCotton cycle with nominal and half load InstallationHints for test institutes Appliance positioningDrying rack unpacking Removing transport safety packagingFor easiest unpacking turn the rack upside down Electrical connectionChanging door stop Remove the elastic band fixing the rack handle to containerPage Intermediate installation kit for stacked washer and dryer Special accessoriesEnvironment Packaging materialOld appliance Pre-draining Drying cycle Environmental tipsService Subject to change without notice