Electrolux 58840R user manual Changing the bulb for interior lighting

Page 33

What to do if ... 33

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The special bulb can be obtained from the Customer Care Department, ET no. 112 552 000-5.

When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open.

WARNING!

Do not use standard bulbs! These develop too much heat and may damage the machine!

WARNING!

Before replacing the bulb, disconnect the mains plug.

1.Unscrew cover above the bulb (this can be found directly behind the loading aperture, at the top; refer to “Description of machine” section.)

2.Replace defective bulb.

3.Screw cover back down.

Check the correct positioning of o-ring gasket before screwing back the door light cover. Do not operate the dryer when missing o-ring gasket on door light cover.

WARNING!

For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer must not be operated.

Image 33

Contents Lavatherm 58840R Dear Customer Contents Service General safety Important safety informationInstallation Use Child safetyProduct description Control panel Before first use What is shown in the displaySorting and preparing laundry Sorting laundryPreparing laundry RPMT/MIN Programme overviewLichte Strijken WOL Daily use Switching machine on / switching light onOpening loading door / loading laundry Selecting the programmeSetting the pre-drainage spin speed Setting dryness levelSelecting additional options If the washing in the washing machine wasFor especially gentle drying of sensitive fab DelicateWhen the option is active, the Sensitive icon is on Long anti-crease phase lengthen the antiSetting delay timer Setting child lockTime Changing programme Starting the programmeDrying cycle complete / removing laundry Open doorClose the door Drying rack Min, from 30 min. up to 180 minutes Care and cleaning Cleaning fluff filterAfter cleaning do not forget to put it back Clean the entire filter area Cleaning the door seal Emptying the condensate tankEmpty condensate tank after every drying cycle Drying cycle Cleaning heat exchangerCare and cleaning Turn both lock washers inwards Cleaning the drumClean operating screen and housing What to do if Troubleshooting by yourselfStart Pauze button Replace defective bulb Screw cover back down Changing the bulb for interior lightingSetting Implementation Buzzer permanent off Machine settingsConsumption values Technical dataHints for test institutes InstallationAppliance positioning Cotton cycle with nominal and half loadDrying rack unpacking Removing transport safety packagingChanging door stop Electrical connectionRemove the elastic band fixing the rack handle to container For easiest unpacking turn the rack upside downPage Intermediate installation kit for stacked washer and dryer Special accessoriesEnvironment Packaging materialOld appliance Pre-draining Drying cycle Environmental tipsService Subject to change without notice