Electrolux 58840R user manual

Page 39

Installation 39

The door stop may only be changed by a specialist. If necessary, please contact our after-sales service or your specialist dealer.

WARNING!

Before changing the door stop, disconnect the mains plug.

1.Open loading door.

2.Unscrew hinge A from the front of the machine and take off the loading door.

3.Remove cover plates B and C. To do this, insert a thin screwdriver into the slots as shown in the illustration, press down- wards slightly and pry out the cover plates.

4.Use an appropriate tool and exert pres- sure to unfasten locking block D from the snap-on fixture, take out and re-in- sert on the other side having rotated the block through 180°.

5.Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite side and screw down.

A	C
B	D
A	C

6.Re-insert cover plates B and C on the opposite site having first rotated them through 180°.

Image 39

Contents Lavatherm 58840R Dear Customer Contents Service General safety Important safety informationInstallation Use Child safetyProduct description Control panel Sorting laundry What is shown in the displayBefore first use Sorting and preparing laundryPreparing laundry RPMT/MIN Programme overviewLichte Strijken WOL Selecting the programme Switching machine on / switching light onDaily use Opening loading door / loading laundryIf the washing in the washing machine was Setting dryness levelSetting the pre-drainage spin speed Selecting additional optionsFor especially gentle drying of sensitive fab DelicateWhen the option is active, the Sensitive icon is on Long anti-crease phase lengthen the antiSetting delay timer Setting child lockTime Changing programme Starting the programmeDrying cycle complete / removing laundry Open doorClose the door Drying rack Min, from 30 min. up to 180 minutes Care and cleaning Cleaning fluff filterAfter cleaning do not forget to put it back Clean the entire filter area Cleaning the door seal Emptying the condensate tankEmpty condensate tank after every drying cycle Drying cycle Cleaning heat exchangerCare and cleaning Turn both lock washers inwards Cleaning the drumClean operating screen and housing What to do if Troubleshooting by yourselfStart Pauze button Replace defective bulb Screw cover back down Changing the bulb for interior lightingSetting Implementation Buzzer permanent off Machine settingsConsumption values Technical dataCotton cycle with nominal and half load InstallationHints for test institutes Appliance positioningDrying rack unpacking Removing transport safety packagingFor easiest unpacking turn the rack upside down Electrical connectionChanging door stop Remove the elastic band fixing the rack handle to containerPage Intermediate installation kit for stacked washer and dryer Special accessoriesEnvironment Packaging materialOld appliance Pre-draining Drying cycle Environmental tipsService Subject to change without notice