Electrolux 58840R user manual Hints for test institutes, Installation, Appliance positioning

Page 36

36Hints for test institutes

Hints for test institutes

Parameters possible to checked by the Test Institutes:

Energy consumption (corrected with final humidity) during the cupboard dry cotton cycle with nominal load.

Energy consumption (corrected with final humidity) during the cupboard dry cotton cycle with half load.

Final humidity (during Cupboard dry cotton, Iron dry cotton and Cupboard dry Easy care)

Condensation efficiency (corrected with final humidity) during cupboard dry

cotton cycle with nominal and half load

All the cycles have to be checked in accordance with IEC 61121 (Tumble dryers for household use – Methods for measuring the performance).

Installation

Appliance positioning

It is recommended that, for your convenience, the machine is positioned close to your washing machine.

The tumble dryer must be installed in a clean place, where dirt does not build up.

Air must be able to circulate freely all round the appliance. Do not obstruct the front ventilation grille or the air intake grilles at the back of the machine.

To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface.

Once in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. If it is not, raise or lower the feet until it is.

The feet must never be removed. Do not restrict the floor clearance through deeppile carpets, strips of wood or similar. This might cause heat built-up which would interfere with the operation of the appliance.

The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The appliance must therefore not be installed on floors which are not resistant to high temperatures.

When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance.

Image 36
Contents Lavatherm 58840R Dear Customer Contents Service Important safety information General safetyInstallation Child safety UseProduct description Control panel What is shown in the display Before first useSorting and preparing laundry Sorting laundryPreparing laundry Programme overview RPMT/MINLichte Strijken WOL Switching machine on / switching light on Daily useOpening loading door / loading laundry Selecting the programmeSetting dryness level Setting the pre-drainage spin speedSelecting additional options If the washing in the washing machine wasDelicate For especially gentle drying of sensitive fabLong anti-crease phase lengthen the anti When the option is active, the Sensitive icon is onSetting delay timer Setting child lockTime Starting the programme Changing programmeDrying cycle complete / removing laundry Open doorClose the door Drying rack Min, from 30 min. up to 180 minutes Care and cleaning Cleaning fluff filterAfter cleaning do not forget to put it back Clean the entire filter area Cleaning the door seal Emptying the condensate tankEmpty condensate tank after every drying cycle Cleaning heat exchanger Drying cycleCleaning the drum Care and cleaning Turn both lock washers inwardsClean operating screen and housing Troubleshooting by yourself What to do ifStart Pauze button Changing the bulb for interior lighting Replace defective bulb Screw cover back downMachine settings Setting Implementation Buzzer permanent offTechnical data Consumption valuesInstallation Hints for test institutesAppliance positioning Cotton cycle with nominal and half loadRemoving transport safety packaging Drying rack unpackingElectrical connection Changing door stopRemove the elastic band fixing the rack handle to container For easiest unpacking turn the rack upside downPage Special accessories Intermediate installation kit for stacked washer and dryerEnvironment Packaging materialOld appliance Environmental tips Pre-draining Drying cycleService Subject to change without notice