K.Microprocessor controller (computer) will not accept any keyboard entries, i.e., L.E.D. display reads "FILL" and when keyboard entries are selected, the L.E.D. display continues to read "FILL" ...
1.Failed keyboard label (touchpad) assembly.
2.Failed microprocessor controller (computer).
L.Microprocessor controller will only accept certain keyboard entries ...
1.Failed keyboard label (touchpad) assembly.
2.Failed microprocessor controller (computer).
M.Microprocessor controller (computer) locks up and L.E.D. display reads erroneous message(s) or only partial segments ...
1.Transient power voltage (spikes)...disconnect power to dryer, wait one (1) minute, and reestablish power to dryer. If problem is still evident ...
a.Failed microprocessor controller (computer).
b.Failed keyboard label (touchpad) assembly.
N.Dryer stops during a cycle and L.E.D. display returns to "FILL" ...
1.Fault in microprocessor heat sensor circuit ...
a.Loose connection in wires between temperature sensor and microprocessor controller (computer).
2.Loose connection somewhere in main power circuit to microprocessor controller (computer).
O.Gas heating unit is not operating (no heat)...no spark at burner area when dryer is first started, and heat indicator dot is on ...
1.Fault in sail switch circuit ...
a.Sail switch is out of adjustment or has failed.
b.Sail switch damper is not closing or is fluttering ...
1)Lint screen is dirty.
2)Restriction in exhaust.
2.Fault in burner
3.Fault in lint chamber sensor bracket
4.Failed Direct Spark Ignition (DSI) module.
5.Failed DSI ignitor /
6.Failed microprocessor controller (computer).
50