4.Blown 24 VAC control circuit fuse (fuse 3).
L.Microprocessor controller (computer) L.E.D. (light emitting diode) display reads "door" and the microprocessor controller (computer) "DOOR" L.E.D. indicator is on...
1.Failed microprocessor controller (computer).
M. Microprocessor controller (computer) will not accept any keyboard (touchpad) entries, i.e., display reads "FILL" and when keyboard (touchpad) entries are selected, the display continues to read "FILL"...
1.Failed keyboard (touchpad) label assembly.
2.Failed microprocessor controller (computer).
N.Microprocessor controller (computer) will only accept certain keyboard (touchpad) entries...
1.Failed keyboard (touchpad) label assembly.
O.Microprocessor controller (computer) locks up and L.E.D. (light emitting diode) display reads erroneous message(s) or only partial segments...
1.Transient power voltage (spikes)...disconnect power to dryer, wait one minute and reestablish power to dryer. If problem is still evident ...
a.Failed microprocessor controller (computer).
b.Failed keyboard (touchpad) label assembly.
P.Dryer stops during a cycle, microprocessor controller (computer) buzzer (tone) sounds for
1.Loose connection somewhere between the microprocessor controller (computer) and the microprocessor temperature sensor.
Q.Dryer stops during a cycle, microprocessor controller (computer) buzzer (tone) sounds only for a few seconds, and then the microprocessor controller (computer) L.E.D. (light emitting diode) display returns to "FILL"...
1.Loose connection somewhere in the main power circuit to the microprocessor controller (computer).
R.Microprocessor controller (computer) L.E.D. (light emitting diode) display reads "SEFL"...
1.Microprocessor controller (computer) program (Program Location 2) is set incorrectly in the active mode ("Sen") where the dryer is not equipped with the optional rotation sensor...program must be set as "nSen."
46