American Dryer Corp AD-24 Phase 7 installation manual NON-COIN Models, Dual Timer Dryers

Page 31

NON-COIN MODELS

1.The light emitting diode (L.E.D.) display reads “READY” (no cycle in progress).

2.Press the letter on the keyboard (touch pad) corresponding to the cycle desired (i.e., key “D”).

NOTE: “0-40” WILL REQUIRE THE “START/ENTER” l KEY TO BE PRESSED AFTER THE NUMBER IS SELECTED IN ORDER TO ACCEPT THE SELECTION AND START DRYING.

3.The dryer will then start. (I.E., blower, basket [tumbler], and heat.)

4.The L.E.D. display will read MANUAL DRYING CYCLE D, 00:00 MIN REMAIN.

NOTE: Press and hold the “UP ARROW” to view the basket (tumbler) temperature at any time.

NOTE: The dryer can be stopped at any time by pressing the “STOP/CLEAR” O key, at this time the dryer will go into a cycle pause. If the “STOP/CLEAR” O key is pressed again at this point, the cycle that was in progress will be cancelled and returned to the “READY” state.

NOTE: Press and hold the “DOWN ARROW” to view the basket (tumbler) RPM.

5.When the programmed drying time has expired, the Phase 7 non-coin microprocessor controller (computer) will proceed into the Cool Down Cycle.

6.Once the Cool Down Cycle begins at the end of the heat cycle, the L.E.D. display will read COOL DOWN TEMP ___/___ MINUTES REMAINING. At the end of the heat cycle, the dryer will shut off the heat and continue the fan and basket (tumbler) until the Cool Down Time or temperature is reached.

IMPORTANT: For more detailed information regarding the microprocessor controller (computer) on your dryer, refer to the microprocessor user’s manual included with the dryer.

DUAL TIMER DRYERS

1. Turn drying timer knob for a time of 20 minutes.

2. Select “High Temp.”

3. Push “Push to Start” button.

4. To stop dryer, open the main door.

Spin and dwell (stop) times are adjustable at the reversing timer.

113222 - 5

www.amdry.com

27

Image 31
Contents AD-24 Installation Manual Retain This Manual in a Safe Place for Future Reference For Your Safety Page Table of Contents Section Procedure for Functional Check Section Safety PrecautionsAmerican Dryer Corp 113222 71.91 cm SpecificationsSpecifications UNPACKING/SETTING UP Installation ProceduresLocation of the Dryer Dryer Enclosure Requirements Fresh AIR Supply Requirements Exhaust Requirements Single Dryer Venting Single Dryer Venting 113222 American Dryer Corp 113222 Important Venting Reminders Electrical Requirements Electrical InformationGas American Dryer Corp 113222 Single-Phase Electrical Lead Connections American Dryer Corp 113222 GAS Information Type of GAS Do not Reduce this Pipe Size Requirement Preoperational Tests Preparation for OPERATION/START-UPBasket Tumbler Coating Preoperational Instructions Coin Models NON-COIN Models Dual Timer DryersShutdown Instructions Reversing Timer SPIN/DWELLADJUSTMENTSService SERVICE/PARTS InformationParts Returning Warranty Parts Warranty InformationReturning Warranty Cards Warranty113222 Cleaning Routine MaintenanceSuggested Cleaning Schedule Lubrication AdjustmentsData Label Information Heat Input for GAS Dryers Data Label Model NumberProcedure for Functional Check Replacement Components 113222 American Dryer Corp 113222 Sensor Activated Fire Extinguishing S.A.F.E. System F.E. System In ActionBefore YOU Start Check Local Codes and Permits InstallationTypical water supply Optional Manual Bypass F.E. System Theory of Operation F.E. System Water Valve Check F.E. System Diagnostics Messages ADC Part No 06/03/08