Changing Cycles, Options, and Modifiers
You can change Sensor Cycles, Timed Cycles, Modifiers, and Options anytime before pressing
NOTE: Three short tones sound if an unavailable combination is selected. The last selection will not be accepted.
Changing Cycles after pressing START-PAUSE
1.Press
2.Select the desired cycle and options.
3.Press and hold
NOTE: If you do not press
Changing Modifiers and Options after pressing Start-Pause
You can change a Modifier or Option anytime before the selected Modifier or Option begins.
1.Press
2.Select the new Modifier and/or Option.
3.Press and hold
Changing the Preset Sensor Cycles Dryness Settings
If all your loads on all Sensor cycles are consistently not as dry as you would like, you may change the preset Sensor Cycles Dryness settings to increase the dryness. This change will affect all of your Sensor cycles.
Your Sensor Cycles Dryness settings can be adjusted to adapt to different installations, environmental conditions or personal preference. There are 3 drying settings: 1 (factory preset dryness level), 2 (slightly dryer clothes, approximately 15% more drying time), and 3 (much dryer clothes, approximately 30% more drying time.)
1.The Sensor Cycles Dryness settings cannot be changed while the dryer is running.
2.Press and hold the Sensor Cycles Dryness button for 5 seconds. The dryer will beep, and “CF” will be displayed on the Estimated Time Remaining screen for 1 second followed by the current drying setting.
3.To select a new drying setting, press the Sensor Cycles Dryness button again until the desired drying setting is shown.
NOTE: While cycling through the settings, the current setting will not flash, but the other settings will flash.
4.Press
5.The drying setting you selected will become your new preset drying setting for all Sensor cycles.
Drying Rack Option
The drying rack is useful for drying items you would not necessarily want to tumble dry or that you would normally line dry (for example, sweaters).
If your model does not have a drying rack, you may be able to purchase one for your model. To find out whether your model allows drying rack usage and for information on ordering, please refer to the front page of the manual or contact the dealer from whom you purchased your dryer.
To use the drying rack
Do not remove the lint screen.
1.Open dryer door.
A
A. Front edge
2.Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner dryer back panel. Push down on front edge of drying rack to secure over the lint screen.
B 
A 
A. Dryer rack front edge
B. Dryer back panel
3.Put the wet items on top of the drying rack. Leave space between the items so air can reach all the surfaces.
NOTE: Do not allow items to hang over the edge of the drying rack.
4.Close the door.
5.Select a timed drying cycle and temperature (see following chart). Items containing foam, rubber, or plastic must be dried on a clothesline or by using the Air Dry temperature setting.
6.You must select a time by pressing the TIME ADJUST up or down buttons. Reset time as needed to complete drying. Refer to the following table.
7.Press and hold
NOTE: Clean the lint screen and remove any lint accumulated from items dried on the drying rack.
9